Abstract:Shorter technology enable us to create higher speed oscillators which can provide better resolution in time domain. Therefore, a simple ADC using voltage (or current) controlled oscillator (VCO) and a counter can be implemented using this approach. Conceptually, the operation order in this ADC is similar to a conventional ΣΔ modulator. The CCO integrates frequency to produce output in the form of phase. And the number of stages in the CCO determines the quantization levels (or phase resolution). The difference of quantized phase output produces a frequency proportional to the input signal. Therefore, unlike, a conventional ΣΔ modulator no feedback is required for a first order noise shaping. In order to achieve a low power for moderate performance two key techniques have been used: a) a cross-coupled voltage to current (V/I) converter to achieve non-linearity cancellation (mainly 3rd-order harmonic), and b) a stack structure to share current between V/I converter and CCO to reduce power. This ADC has been simulated using models of typical 130nm CMOS technology. In SPICE simulation, SQDR/SFDR of 67.5 dB/71 dB is achieved over a total signal bandwidth of 5 MHz for an input swing of 300mV (Vpp) for typical corner at room temperature. The analog blocks consumed a total of 96.5μW from a regulated 1.2V supply, whereas, the digital blocks consumed an estimated power of 1.1 mW. Since, the major circuit blocks are digital in nature, the presented circuit is highly amenable with technology scaling.

A 174.3-Db FoM VCO-Based CT $\delta \sigma $ Modulator with a Fully-Digital Phase Extended Quantizer and Tri-Level Resistor DAC in 130-Nm CMOS

A 74.5-dB Dynamic Range 10-MHz BW CT-ΔΣ ADC With Distributed-Input VCO and Embedded Capacitive- π Network in 40-nm CMOS

A 10.7-Μa 103-Db DR Hybrid Delta-Sigma Modulator for Sensing Applications

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

A 0.18 μm Single-poly CMOS ∑-△ Modulator for Digital Audio Applications

An 81.5Db-Dr 1.25Mhz-Bw VCO-Based CT ΔΣ ADC with Double-PFD Quantizer

A 70db SNDR 20Mhz-Bw VCO-Based CT Sturdy MASH Delta-Sigma Modulator with Robust Quantization Error Extraction

A VCO Based Continuous Time Delta Sigma ADC with 10mhz BW 55db SNR and 42db SNDR

A 14b continuous-time delta-sigma modulator with 2MHz signal bandwidth

An OTA-Less Second-Order VCO-Based CT $\delta\sigma$ Modulator Using an Inherent Passive Integrator and Capacitive Feedback

Vco-Based Continuous-Time Sigma Delta Adc Based on A Dual-Vco-Quantizer-Loop Structure

A 1V 350μW 92dB SNDR 24 kHz ΔΣ modulator in 0.18μm CMOS

A 1.2 mW 67.5 dB SQDR VCO-based ΣΔ ADC with Non-linearity Cancellation Technique

A Second-Order Purely VCO-Based CT $\delta\sigma$ ADC Using a Modified DPLL Structure in 40-Nm CMOS

Highly Linear Continuous-Time Mash Delta Sigma Adc With Dual Vco-Based Quantizers

Highly Linear Continuous-Time MASH ΔΣ ADC with Dual VCO-based Quantizers

A 0.6V 19.5 mu W 80 dB DR Delta Sigma Modulator with SA-Quantizers and Digital Feedforward Path

A 0.028mm<sup>2</sup> 19.8fJ/step 2<sup>nd</sup>-order VCO-based CT ΔΣ modulator using an inherent passive integrator and capacitive feedback in 40nm CMOS

Design of a High-speed Wide-band Continuous-Time Delta-Sigma Modulator

20.5 A 76.6dB-SNDR 50MHz-BW 29.2mW Noise-Coupling-Assisted CT Sturdy MASH ΔΣ Modulator with 1.5b/4b Quantizers in 28nm CMOS

A 9-Mw Continuous-Time Hybrid Active-Passive Sigma Delta Modulator With 84-Db Dynamic Range