Abstract:Shorter technology enable us to create higher speed oscillators which can provide better resolution in time domain. Therefore, a simple ADC using voltage (or current) controlled oscillator (VCO) and a counter can be implemented using this approach. Conceptually, the operation order in this ADC is similar to a conventional ΣΔ modulator. The CCO integrates frequency to produce output in the form of phase. And the number of stages in the CCO determines the quantization levels (or phase resolution). The difference of quantized phase output produces a frequency proportional to the input signal. Therefore, unlike, a conventional ΣΔ modulator no feedback is required for a first order noise shaping. In order to achieve a low power for moderate performance two key techniques have been used: a) a cross-coupled voltage to current (V/I) converter to achieve non-linearity cancellation (mainly 3rd-order harmonic), and b) a stack structure to share current between V/I converter and CCO to reduce power. This ADC has been simulated using models of typical 130nm CMOS technology. In SPICE simulation, SQDR/SFDR of 67.5 dB/71 dB is achieved over a total signal bandwidth of 5 MHz for an input swing of 300mV (Vpp) for typical corner at room temperature. The analog blocks consumed a total of 96.5μW from a regulated 1.2V supply, whereas, the digital blocks consumed an estimated power of 1.1 mW. Since, the major circuit blocks are digital in nature, the presented circuit is highly amenable with technology scaling.

A 1.2 mW 67.5 dB SQDR VCO-based ΣΔ ADC with Non-linearity Cancellation Technique

A 14-Bit 500-Ms/S Sha-Less Pipelined Adc In 65nm Cmos Technology For Wireless Receiver

A 1.8mW 2MHz-BW 66.5dB-SNDR ΔΣ ADC using VCO-based integrators with intrinsic CLA

A 1.5 Mw 68 Db SNDR 80 Ms/s 2<formula Formulatype="inline"> <tex Notation="TeX">$\times$</tex></formula> Interleaved Pipelined SAR ADC in 28 Nm CMOS

A Second-Order Purely VCO-Based CT $\delta\sigma$ ADC Using a Modified DPLL Structure in 40-Nm CMOS

An 81.5Db-Dr 1.25Mhz-Bw VCO-Based CT ΔΣ ADC with Double-PFD Quantizer

A 0.04-Mm2 0.9-Mw 71-Db SNDR Distributed Modular AS ADC with VCO-based Integrator and Digital DAC Calibration

Vco-Based Continuous-Time Sigma Delta Adc Based on A Dual-Vco-Quantizer-Loop Structure

A 10MHz-BW, 5.6mW, 70dB SNDR ΔΣ ADC using VCO-based integrators with intrinsic DEM

A Second-Order VCO-Based ΔΣ ADC with Fully Digital Feedback Summation.

A VCO Based Continuous Time Delta Sigma ADC with 10mhz BW 55db SNR and 42db SNDR

A Scaling-Friendly Low-Power Small-Area <formula Formulatype="inline"><tex Notation="TeX">$\Delta\Sigma$</tex></formula> ADC with VCO-Based Integrator and Intrinsic Mismatch Shaping Capability

A 74.5-dB Dynamic Range 10-MHz BW CT-ΔΣ ADC With Distributed-Input VCO and Embedded Capacitive- π Network in 40-nm CMOS

An 80.2-to-89.1dB-SNDR 24k-to-200kHz-BW VCO-Based Synthesized ?S ADC with 105dB SFDR in 28-nm CMOS

A 0.025-Mm 2 0.8-V 78.5-Db SNDR VCO-Based Sensor Readout Circuit in a Hybrid PLL- $\delta\sigma$ M Structure

A hybrid SAR-VCO ΔΣ ADC with first-order noise shaping

A 174.3-Db FoM VCO-Based CT $\delta \sigma $ Modulator with a Fully-Digital Phase Extended Quantizer and Tri-Level Resistor DAC in 130-Nm CMOS

A Hybrid Sar-Vco Delta Sigma Adc With First-Order Noise Shaping

A Purely-Vco-based Single-Loop High-Order Continuous-Time ΣΔ ADC.

A 0.6-to-1.2 V Scaling-Friendly Discrete-Time OTA-Free Linear VCO-Based TEXPRESERVE0 ADC Suitable for DVFS

A Synthesizable 0.0060mm2 VCO-Based Delta Sigma Modulator with Digital Tri-level Feedback Scheme.