Abstract:The pipelined-SAR ADC has become popular in wide-bandwidth and high-resolution applications due to its power-efficient architecture [1]. In the pursuit of higher ADC speeds while maintaining precision and power efficiency, not only does the conversion time of the SAR sub-ADC need to be shortened, but also the speed and gain of residue amplifiers (RA) need to be enhanced. Conventional solutions to these two problems, including reducing the bit-cycling time of the SAR and increasing the RA bandwidth, often require extensive power costs, leading to a degraded power efficiency. To address the speed and gain challenges, three techniques are proposed in this work. First, a continuous-time SAR-assisted detect-and-skip (CTDAS) to parallelize the MSB conversion with ADC sampling, thus cutting down the $1^{\text{st}}$-stage sampling and conversion time by 35% when compared with a conventional detect-and-skip (DAS) technique. Second, an open-then-close correlated level shifting (OCCLS) technique applied in the residue amplifier, which significantly speeds up the first phase by open-loop amplification reusing the first two high-bandwidth stages of the RA. With the aid of a detect-and-cut loop, an optimal voltage gain in the first phase is obtained across PVT variations, thus realizing an >80dB equivalent RA open-loop gain $\left(\mathrm{A}_{\mathrm{EO}}\right)$ across PVT variations. Third, a hybrid static-floating ringamp architecture is implemented to improve the noise performance of the RA and to fit in well with the OCCLS scheme. Thanks to the techniques above, the 22nm prototype achieves 70.7dB SNDR under 200MS/s while consuming 2.0mW from a 0.9V supply. It measures a best energy efficiency of 177.7dB Schreier FoM with fs >150MS/s.

A 1.5 Mw 68 Db SNDR 80 Ms/s 2<formula Formulatype="inline"> <tex Notation="TeX">$\times$</tex></formula> Interleaved Pipelined SAR ADC in 28 Nm CMOS

A 12-Bit 2.32gs/s Pipelined/sar Hybrid ADC with a High-Linearity Input Buffer.

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A Low-Power 12-Bit 2gs/S Time-Interleaved Pipelined-Sar Adc In 28nm Cmos Process

9.1 A 2mW 70.7dB SNDR 200MS/s Pipelined-SAR ADC with Continuous-Time SAR-Assisted Detect-and-Skip and Open-then-Close Correlated Level Shifting.

A 12-bit 100-MSps pipelined-SAR ADC with a time-interleaved second-stage

A 68.5 Db-Sndr, 12.4-Fj/conv.-step, 100-Ms/s Pipelined-Sar ADC with PVT-enhanced Circuitry

An 871nw 96.2Db-Sndr Pipelined NS SAR ADC Achieving 180.8Db-Fomsndr with a Charge-Efficient CLS-Assisted Two-Stage FIA

A 12-Bit 1.5-Gs/s Single-Channel Pipelined SAR ADC with a Pipelined Residue Amplification Stage

A 12-bit 1.1GS/s Pipelined-SAR ADC With Adaptive Inter-Stage Redundancy in 28 nm CMOS

9.3 A 71dB SNDR 200MHz BW Interleaved Pipe-SAR ADC with a Shared Residue Integrating Amplifier Achieving 173dB FoMs.

A 2-Mw 70.7-Db SNDR 200-Ms/s Pipelined-SAR ADC Using Continuous-Time SAR-Assisted Detect-and-Skip and Open-Then-Close Correlated Level Shifting

A 14-Bit 200ms/s Low-Power Pipelined Flash-Sar ADC.

An 85mW 14-bit 150MS/s pipelined ADC with 71.3dB peak SNDR in 130nm CMOS

A 130-MS/s 10-Bit Asynchronous SAR ADC with 55.2 dB SNDR

A 8-bit 125-MSample/s pipelined ADC

An energy-efficient reconfigurable 18/12-bit 1MS/s pipelined-SAR ADC

A 10mw 10-ENOB 1gs/s Ring-Amp-Based Pipelined TI-SAR ADC with Split MDAC and Switched Reference Decoupling Capacitor.

An 871 Nw 96.2 Db SNDR Pipelined Second-Order Noise-Shaping SAR ADC Employing Charge-Efficient CLS-Assisted Residue Amplifier

A 91.0-Db SFDR Single-Coarse Dual-Fine Pipelined-SAR ADC with Split-Based Background Calibration in 28-Nm CMOS.

A 1.8-V 11-Bit 40-Ms/s 21-Mw Pipelined ADC

A 1.5 Mw 68 Db SNDR 80 Ms/s 2&lt;formula Formulatype="inline"&gt; &lt;tex Notation="TeX"&gt;$\times$&lt;/tex&gt;&lt;/formula&gt; Interleaved Pipelined SAR ADC in 28 Nm CMOS