Abstract:AlN is regarded as a promising ceramic material for high performance structural and high temperature applications due to its superior properties such as high thermal conductivity, excellent stability and wear resistance. However, challenges remain in fabricating AlN ceramics with high strength and high thermal shock resistance. In this work, AlN/YAlO3 composites with different YAlO3 contents (3–10 wt%) were prepared by a simple pressureless sintering method, and the impact of YAlO3 content on mechanical properties and thermal shock resistance of AlN/YAlO3 composites was investigated. Results show that the grain growth of AlN is inhibited and the densification is improved with the addition of 3 wt% and 5 wt% YAlO3. Hence, the flexural strength and fracture toughness of AlN/YAlO3 composites are improved due to the grain refinement and compactness enhancement, and the highest value, 369 MPa and 3.84 MPa m1/2, are reached by the AlN-5 wt% YAlO3 composite. Moreover, the thermal shock resistance was assessed through theoretical forecast and cyclic thermal shock tests over a temperature range between 1000 °C and 1600 °C. Comparing with pure AlN, the thermal stress damage resistance parameters (R IV ) of AlN/YAlO3 composites were increased, while their residual strengths and retention ratios after 10–50 cycles of thermal shock tests maintained a higher level as well. Microstructure analysis revealed that the thermal shock resistance of AlN/YAlO3 composites was evidently improved attributing to various strengthening mechanisms such as crack deflection, crack branching and microcrack toughening.

Fabrication And Plasma Arc Thermal Shock Resistance Of Hfb2-Based Ultra High Temperature Ceramics

Enhanced thermal shock resistance of BN-based composites sintered by hot-pressing with the introduction of nano oxides

Microstructure, mechanical properties and thermal shock behavior of h-BN-SiC ceramic composites prepared by spark plasma sintering

Effect of HfC addition on ablation behavior of SiBCN ceramics

Preparation of AlN microspheres/UHMWPE composites for insulating thermal conductors

YAlO3 reinforced AlN composite ceramics with significantly improved mechanical properties and thermal shock resistance

Influence of Tungsten Carbide Particles on Resistance of Alumina Matrix Ceramics to Thermal Shock

High temperature ablation of hot pressed HfC‐SiC ceramics

Thermal Shock Resistance of in Situ Formed Si2N2O–Si3N4 Composites by Gelcasting

Ablation behaviors of ultra-high temperature ceramic composites

Thermoablative behaviors of designable hafnium carbonitride integrated with lattice of tungsten upon 3273K

Effect of SiC Content on the Ablation and Oxidation Behavior of ZrB2-Based Ultra High Temperature Ceramic Composites

Densification, microstructure and properties of ultra-high temperature HfB2 ceramics by the spark plasma sintering without any additives

Fabrication and Surface Hardening Properties for SiC/AlN Ceramic Composites with Different SiC Grain Size

Thermal Ablation Resistance of Melt-Infiltrated Titanium Diboride-(Copper, Nickel) Composites

Study on Thermal Shock Resistance of Alumina Composite Ceramics by Indention Quenching Method

Effect of SiC on Microstructure, Phase Evolution, and Mechanical Properties of Spark-Plasma-Sintered High-Entropy Ceramic Composite

Design and characterization of therm-al shock resistance of several typical zirconia reinforced alumina ceramic composites

Fabrication of high-temperature resistant Y–Al–Si–O composite ceramics with enhanced mechanical/thermal/dielectric properties

Long-term ablation mechanisms of the YB4-Al2O3-Si3N4 modified Cf/HfC-SiC composites at 2600 °C