Abstract:The process of preparing SiC fiber-reinforced γ -TiAl composites by the conventional methods is difficult and complicated due to the high reactivity, high melting point and poor deformability of γ -TiAl alloys. In this work, suction casting, a promising method for preparing SiC f /TiAl composite, had been attempted. In the process, γ -TiAl alloy melt was introduced rapidly into a mold within pre-arranged fibers that were coated with additional layer of titanium alloy. This simple method successfully prevented serious reactions between the alloy melt and the fibers which remained intact during the solidification process. The interfacial reaction layer was observed by optical microscopy, scanning electron microscopy (SEM). The interfacial reaction products were identified by transmission electron microscopy (TEM). Tensile tests of the matrix alloy and composites were performed at room temperature and 800 °C. The results exhibited that the tensile strength of SiC f / γ -TiAl composite was higher than that of the matrix alloy at both room temperature and 800 °C. At room temperature, tensile strength of SiC f / γ -TiAl composite was increased by about 7% (50 MPa), whereas a double increase in tensile strength 14% (100 MPa) was obtained at 800 °C. The titanium alloy coating on the fiber not only prevented the serious interfacial reaction between the γ -TiAl alloy melt and the SiC fiber, but also played a role in delaying the propagation of cracks in the matrix to the fiber at 800 °C. The fracture mechanism of the composite was analyzed by fracture metallographic analysis.

Thermal Shock Resistance of in Situ Formed Si2N2O–Si3N4 Composites by Gelcasting

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Fabrication and Properties of SiO2-BN-Si3N4 Composites

Enhanced thermal shock resistance of BN-based composites sintered by hot-pressing with the introduction of nano oxides

Microstructure and Properties of Si3N4 Based on Gelcasting

In-Situ formation of the BSG bubbles toward SiC/SiC composites protection mechanisms under thermal shock treatment

Thermal Shock Behavior of Sic Whisker Reinforced Si3n4/Bn Fibrous Monolithic Ceramics

Pressureless Sintering and High-Temperature Strength of SiC-AlN Ceramics

Thermal Shock Behavior of Si3N4/BN Fibrous Monolithic Ceramics

Sintering behaviour and mechanical properties of SiC/YAG composite powders by sol-gel methods

Effect of thermal shock induced dislocation multiplication on the thermal conductivity of 60 vol% SiCp/Al–7Si composites

Microstructure, mechanical properties and thermal shock behavior of h-BN-SiC ceramic composites prepared by spark plasma sintering

Properties evolution and damage mechanism of SiC/SiC composites after thermal shock at 1300 °C

Thermal Shock and Residual Strength Testing of SiC/SiC Composite Braided Tubes

Enhancement of thermal shock resistance in β-Si3N4 coating with in situ synthesized β-Si3N4 nanowires/nanobelts on porous Si3N4 ceramics

Mechanical Properties and Thermal Shock Resistance of Fine-Grained Nd:YAG/SiC Ceramics

Effects of MgSiN2 Addition and Post-Annealing on Mechanical and Thermal Properties of Si3N4 Ceramics

Tensile Behavior of SiC Fiber-Reinforced Γ -Tial Composites Prepared by Suction Casting

Fabrication, microstructure, and properties of SiC/Al4SiC4 multiphase ceramics via an in-situ formed liquid phase sintering

Si3N4-SiC ceramic nanocomposites