Abstract:This paper presents a group-selected (GS) and gain controllable (GC) active mixer designed for ultra-wide-band (UWB) receiver. The double-balanced Gilbert-type configuration, current bleeding technique and resonating technique for tail capacitance are incorporated in the proposed mixer. A switched capacitance network (SCN) is used to control the resonant frequency of the tail capacitance for the group selection. Digitally controlled tail current source and bleeding current source are used to justify and compensate the loss of conversion gain due to the switched capacitance network while working at low frequency groups. These two techniques greatly enhance the conversion gain and noise performance in each group. Designed in a standard 0.18-μm CMOS technology, the mixer achieves a conversion gain of 17dB, a minimum noise figure of 7.31dB and an input IP3 of -6dBm over the 3.432GHz~7.656GHz frequency range for UWB groups #1~#3. It consumes a minimum 9mW from a 1.8V supply.

A 0.18 Mu M Cmos High Linearity Flat Conversion Gain Down-Conversion Mixer For Uwb Receiver

A 0.18μm CMOS high linearity flat conversion gain down-conversion mixer for UWB receiver

A group-selected and gain controllable CMOS active mixer for UWB applications

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 0.13μm CMOS Low-Voltage High-Linearity Mixer for UWB Receiver

A 0.13&#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer

A low-power reconfigurable mixer for MB-OFDM UWB receivers

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A High Conversion Gain Wideband Mixer Design for UWB Applications

Design of Low Voltage Up-Conversion Mixer for Wsn Applications

A 2.4ghz Low Power Highly Linear Mixer For Direct-Conversion Receivers

Fully Differential CMOS LNA and Down-Conversion Mixer for 3-5 GHz MB-OFDM UWB Receivers

A High Linearity Dual-Band Mixer for IMT-A and UWB Systems

A LOW POWER, HIGH-LINEARITY CMOS DOWNCONVERSION FOLDED MIXER FOR 2.4GHz ISM BAND APPLICATIONS

A high linearity reconfigurable down-conversion mixer for dual-band applications

A 5.15-5.825ghz Cmos Down-Conversion Mixer For Wlan 802.11a

A 1.8–2.6GHz RF CMOS up-conversion mixer for wideband applications

A 1.9 GHz High Linearity CMOS Up-mixer

A high linearity CMOS up-conversion mixer for UHF RFID reader application