Abstract:This paper presents a group-selected (GS) and gain controllable (GC) active mixer designed for ultra-wide-band (UWB) receiver. The double-balanced Gilbert-type configuration, current bleeding technique and resonating technique for tail capacitance are incorporated in the proposed mixer. A switched capacitance network (SCN) is used to control the resonant frequency of the tail capacitance for the group selection. Digitally controlled tail current source and bleeding current source are used to justify and compensate the loss of conversion gain due to the switched capacitance network while working at low frequency groups. These two techniques greatly enhance the conversion gain and noise performance in each group. Designed in a standard 0.18-μm CMOS technology, the mixer achieves a conversion gain of 17dB, a minimum noise figure of 7.31dB and an input IP3 of -6dBm over the 3.432GHz~7.656GHz frequency range for UWB groups #1~#3. It consumes a minimum 9mW from a 1.8V supply.

A 1.8–2.6GHz RF CMOS up-conversion mixer for wideband applications

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A group-selected and gain controllable CMOS active mixer for UWB applications

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

A Gm-boosted and current peaking wideband merged LNA and mixer

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A 1.9 GHz High Linearity CMOS Up-mixer

A 24‐ghz Active Up/down Bidirectional Mixer in 130‐nm RF CMOS

A 0.18μm CMOS high linearity flat conversion gain down-conversion mixer for UWB receiver

A 0.18 Mu M Cmos High Linearity Flat Conversion Gain Down-Conversion Mixer For Uwb Receiver

A 3.3-V, 1.9-Ghz, High Linear CMOS Up-Mixer with Multi-tanh Linearization Technique

A LOW POWER, HIGH-LINEARITY CMOS DOWNCONVERSION FOLDED MIXER FOR 2.4GHz ISM BAND APPLICATIONS

A 62–85-Ghz High Linearity Upconversion Mixer with 18-Ghz IF Bandwidth

A 27.5‐43.5 GHz 65‐nm CMOS Up‐conversion Mixer with 0.42 Dbm OP1dB for 5G Applications

A High Conversion Gain Wideband Mixer Design for UWB Applications

Optimizing Mixer Noise Performance: A 2.4 Ghz Gilbert Downconversion Mixer for W-Cdma Application

2.4 GHz 0.35μm CMOS gilbert down-conversion mixer

A 27.5–43.5 GHz High Linearity Up-Conversion CMOS Mixer for 5G Communication

A 2.4ghz Low Power Highly Linear Mixer For Direct-Conversion Receivers

3.5 Ghz To 10.0 Ghz Mixers Of High Gain And Good Isolations