Abstract:The solidification behaviours and microstructural characteristics of both ZA27/SiCp composites and monolithic ZA27 alloy were studied by using differential scanning calorimetry, scanning electron microscopy, transmission electron microscopy, electron probe microanalysis, and X-ray diffraction, It was found that there were differences in the transformation temperature and volume fraction of the phases, although the solidification process was almost identical for the composite and the monolithic alloy. The incorporation of SiC particles in the ZA27 alloy led to slight refinement of primary grains and reduced volume fraction of eutectic-like phase. The SiC particles obstructed Zn diffusion in the residual melt during the formation of proeutectic beta phase, but promoted Zn diffusion from alpha (Al) to eta (Zn) phase during eutectoid transformation. During solidification, Cu was mainly segregated in the final solidification regions; Mg was present not only in the matrix but also on SiC particles; and oxide inclusions were mainly distributed around SiC particles, The matrix microstructure for both materials mainly consisted of primary cores of Al rich alpha + eta eutectoid; beta' phase resulting from the eutectoid transformation of the proeutectic beta phase; and Zn rich alpha + eta eutectoid resulting from the eutectoid transformation of the eutectic-like phase. The SiC particles were mainly distributed around the primary grains, Several new phases based on the Al-Zn-Mg-Cu system and interfacial reaction products, including Al21Fe3Si, Cu5Zn8, Mg6Cu3Al7, MgAl2O4, and amorphous oxide inclusions, were identified in the final solidification regions. The nucleation of both primary alpha phase and eutectic-like alpha + eta phase at the surface of SIC particles and their crystallographic orientation relationships were investigated theoretically and experimentally. No distinct crystallographic orientation relationship between the matrix and SiC has been identified, although the mismatch between (0001)(SiC) and (111)(alpha) was calculated to be as small as 7.6%.

Electrophoretic Deposition Forming of Sic-Tzp Composites in A Nonaqueous Sol Media

Fabrication and Characterization of Y2O3 Stabilized ZrO2 Films Deposited with Aerosol-Assisted MOCVD

Deposition of Y2O3 stabilized ZrO2 thin films from Zr(DPM)4 and Y(DPM)3 by aerosol-assisted MOCVD

Synthesis of YSZ film by solid single source PE-MOCVD method and characterization

Electrophoretic Deposition of Pb(Zr,Ti)O3 Powders on Silicon Wafer and Sintering Densification Approach

Fabrication of SiC Dense-Porous Laminates by Electrophoretic Deposition Process

Reply to “comment On‘electrophoretic Deposition Forming of SiC‐TZP Composites in a Nonaqueous Sol Media'”

Effect of Hcl on Electrophoretic Deposition of Yttria Stabilized Zirconia Particles in Organic Solvents

Electrophoretic Deposition of Pb(Zr, Ti)O-3 Powder on Si Wafer: Morphological Change Across Film Thickness

Preparation of Yttria stabilized Zirconia (YSZ) film by electrophoretic deposition (EPD) method

Preparation of Yttria-Stabilized Zirconia(ysz)films by an Electrophoretic Deposition Method

Solidification and microstructure of ZA27/SiCp composite fabricated by mechanical-electromagnetic combination stirring process

SiC platelet and SiC platelet−alumina reinforced TZP matrix composites

Characterisation of interfacial bonding in Al2O3 coated SiC whisker reinforced TZP composites

Investigation of Electrodeposition External Conditions on Morphology and Texture of Ni/SiCw Composite Coatings

Deposition mechanism of convex YSZ particles and effect of electrolyte/cathode interface structure on cathode performance of solid oxide fuel cell

Formation of Sic Nanostruture Using Hexamethyldisiloxane During Plasma-Assisted Hot-Filament Chemical Vapor Deposition

Composite modification of fine SiC powder by 3-aminopropyl triethoxysilane and sodium polystyrene sulfonate and its slip casting study

Pretreatment Process of SiC Particles and Fabrication Technology of SiC Particulate Reinforced Zn–Al Alloy Matrix Composite

Ultrasound Supported Galvanostatic Deposition of Zn Coatings Reinforced with Nano-, Submicro-, and Micro-SiC Particles—Weak Acidic Chloride Baths

Mechanical Properties and Microstructure of Sic-Zro2(3y)-Al2o3 Nanocomposites