Abstract:Li 7 La 3 Zr 2 O 12 (LLZO) garnet-type lithium-ion conductors are being investigated as a promising solid electrolyte for solid-state lithium batteries. To enable a functional all-solid-state configuration intensive investigations are needed to reduce the cathode/electrolyte interfacial resistance which contributes the most to cell performance loss. Among the commercial cathode materials investigated so far, LiCoO 2 (LCO) is one of the most stable with garnet electrolytes as only a superficial reaction has been detected between the two materials. However, even this minor reaction would block the Li-ion transport through the interface, resulting in deteriorated cell performance. In this work, we demonstrate that a thin aluminum oxide layer (5 nm) can be an effective interlayer to impede the formation of a harmful interphase and enable facile Li-ion transfer between LCO and the LLZO garnet. Room-temperature-sputtered LCO thin films were employed to form an interface with the garnet electrolyte and annealed at 800 °C to reveal the effect of the interfacial reaction on the Li-ion transfer across the interface. An aluminum oxide layer was then introduced between LCO and the garnet electrolyte by sputtering a metallic aluminum layer which is then annealed together with the upper LCO layer in oxygen, or by direct atomic layer deposition of the oxide. Compared to the LCO/LLZO/Li cells without an aluminum oxide interlayer, those with the interlayer exhibited improved performance, i.e., a stable discharge capacity of up to 90 mAh/(g LCO) at a C/10 rate, a rate capability up to 1.68C and a stable galvanostatic cycling at 0.1C for over 100 cycles with a discharge capacity fade rate of 0.15% per cycle. It was determined that aluminum diffused into the LCO layer after preventing the initial detrimental reaction between LCO and the LLZO garnet from happening during high temperature annealing, suggesting that the coating does not have to remain a physically blocking layer during cycling to function.

Cu-Doped Alloy Layer Guiding Uniform Li Deposition on a Li-LLZO Interface under High Current Density.

In Situ Fabrication of High Ionic and Electronic Conductivity Interlayers Enabling Long-Life Garnet-Based Solid-State Lithium Batteries

Achieving Efficient and Stable Interface Between Metallic Lithium and Garnet-Type Solid Electrolyte Through a Thin Indium Tin Oxide Interlayer

All Solid-State Li/LLZO/LCO Battery Enabled by Alumina Interfacial Coating

An in Situ-Formed LiI Interface Layer for Garnet-Based Lithium Metal Batteries

A Simple and Efficient Strategy for Ameliorating Li/LLZO Interfacial Contact

Regulation Mechanism on A Bilayer Li 2 O‐Rich Interface between Lithium Metal and Garnet‐Type Solid Electrolytes

Three-dimensional alloy interface between Li6.4La3Zr1.4Ta0.6O12 and Li metal to achieve excellent cycling stability of all-solid-state battery

Anchoring an Artificial Solid–Electrolyte Interphase Layer on a 3D Current Collector for High‐Performance Lithium Anodes

Constructing a Li2O/LiZn Mixed Ionic Electron Conductive Layer by Ultrasonic Spraying to Enhance Li/Garnet Solid Electrolyte Interface Stability for Solid-State Batteries.

Improvement of Ionic Conductivity in Li7La3Zr2O12 (LLZO) Solid Electrolyte By Doping with Aluminum/Tungsten

LiCoO2 Sintering Aid Towards Cathode-Interface-enhanced Garnet Electrolytes

Co-doping strategy enhanced the ionic conductivity and excellent lithium stability of garnet-type Li7La3Zr2O12 electrolyte in all solid-state lithium batteries

In-situ construction of Li-Mg/LiF conductive layer to achieve an intimate lithium-garnet interface for all-solid-state Li metal battery

In-situ constructed lithium-salt lithiophilic layer inducing bi-functional interphase for stable LLZO/Li interface

Reducing Impedance at a Li-Metal Anode/Garnet-Type Electrolyte Interface Implementing Chemically Resolvable In Layers

Rational Design of Lamellar Mixed Ion/Electron Conductive Layer for Dendrite-Free Garnet-Based Solid State Batteries

In Situ Formed Surface Layer to Improve the Air Stability of LLZTO and Its Contact with the Li Metal

A Low-Cost Al-doped Garnet Li7La3Zr2O12 with High Ionic Conductivity for High-Energy Solid-State Lithium Metal Batteries

Synergistically Engineering Grains and Grain Boundaries toward Li Dendrite-Free Li7La3Zr2O12

Enhanced Critical Current Density in the Garnet Oxide Electrolyte by a Silver Interlayer