Abstract:Thermal and non-thermal plasma processes have been considered as potential methods for continuous gas synthesis of graphene in recent years. A novel approach for the preparation of few-layer graphene nano-flakes (GNFs) is presented in this work. The GNFs are continuously synthesized by non-thermal decomposition of hydrocarbons using a magnetically rotating arc at atmospheric pressure. The products are characterized by transmission electron microscopy (TEM), Raman spectrum, BET measurements and X-ray photoelectron spectroscopy (XPS). The effects of arc current, feedstock gas type, feedstock gas flow rate, C/H mole ratio and buffer gas type on the morphologies and microstructures of pyrolysis products are investigated and discussed. Results show that low power, low carbon concentration and high hydrogen concentration are considered the essential condition for the formation of GNFs. The synthesized GNFs are agglomerative flakes, where each flake is between 50 and 300 nm. Material analyses indicate that the GNFs have excellent properties such as a good crystalline structure, a high purity, a low number of layers, and a large specific surface area. Such characteristics suggest that the GNFs could be applied in fuel cells and energy storages. Building on the above results, a possible nucleation mechanism of graphene is proposed. On the one hand, low concentration of graphene nucleating precursor-polycyclic aromatic hydrocarbons (PAHs), is a necessary condition for the formation of GNFs. A process of slow rate of nucleation and rapid surface growth may occur during the GNFs formation[1]. On the other hand, low C/H mole ratio can form mass activated hydrogen atoms which terminate dangling bonds at edge of graphene and prevent the bending of carbon, that promotes the formation of GNFs[2]. Compared with GNFs prepared in other non-thermal plasmas, this method has a lower energy cost (<0.3 kWh/g ) and no pollution while guaranteeing the quality of GNFs. It is anticipated that the method developed in this paper will be highly advantageous for the mass and continuous productions of GNFs. Additionally, the morphologies and microstructures of final products can be adjusted easily by controlling the operating parameters. Figure 1 Schematic diagram of the experimental apparatus

Large-scale In-Situ Synthesis of Nitrogen-Doped Graphene Using Magnetically Rotating Arc Plasma

In Situ Synthesis of Nitrogen-Doped Graphene Nanoflakes Using Non-Thermal Arc Plasma

Catalyst-free, tunable doping content of graphitic-N in arc-discharged graphene via gas and solid nitrogen sources and their formation mechanisms

Large scale synthesis of N-doped multi-layered graphene sheets by simple arc-discharge method

In Situnitrogen-Doped Graphene Grown from Polydimethylsiloxane by Plasma Enhanced Chemical Vapor Deposition

Effects Of Buffer Gas On N-Doped Graphene In A Non-Thermal Plasma Process

One-step Synthesis of Nitrogen-Doped Graphene from a Sole Aromatic Precursor

Continuous synthesis of graphene nano-flakes by non-thermal plasma with a magnetically rotating arc at atmospheric pressure

Synthesis of nitrogen doped graphene with high electrocatalytic activity toward oxygen reduction reaction

One-step Thermal-Plasma Synthesis of Sulphur and Nitrogen Dual-Doped Graphene with Improved Microwave-Absorption Efficiency

A Simple Method to Synthesize Continuous Large Area Nitrogen-Doped Graphene

Low pressure chemical vapor deposition synthesis of large area hetero-doped mono- and few- layer graphene with nitrogen and oxygen species

Production of Nitrogen-Doped Graphene by Low-Energy Nitrogen Implantation

Synthesis of Nitrogen-Doped Graphene Using Embedded Carbon and Nitrogen Sources

Catalyst-free Synthesis of Nitrogen-Doped Graphene Via Thermal Annealing Graphite Oxide with Melamine and Its Excellent Electrocatalysis.

Atomic Resolution of Nitrogen-Doped Graphene on Cu Foils.

Synthesis of N-doped graphene film with tunable graphitic and pyridinic doping content

Synthesis of Nitrogen-Doped Graphene by Chemical Vapour Deposition Using Melamine As the Sole Solid Source of Carbon and Nitrogen

Synthesis of Graphene Flakes Using a Non-Thermal Plasma Based on Magnetically Stabilized Gliding Arc Discharge

Effects of Buffer Gases on Graphene Flakes Synthesis in Thermal Plasma Process at Atmospheric Pressure

Continuous synthesis of graphene nano-flakes by magnetically rotating arc at atmospheric pressure