Abstract:A high-selectivity bandpass filter (BPF) based on two merged ring resonators is presented in this paper. The structure of this proposed BPF can be seen as the two one-wavelength ring resonators merged each other by sharing the common lambda(g)/2 microstrip line. Due to symmetric structure, it can be analyzed by even- and odd-mode method and the locations of six transmission zeros are calculated using input impedance deductions. For further demonstration, a BPF example centered at 2 GHz is fabricated with high frequency selectivity. The measured 3-dB fractional bandwidth is 11% (1.89-2.11 GHz) and insertion loss is less than 2 dB in the passband. Good agreement between simulation and measurement verifies the feasibility of the design method. this method is at the expense of a large circuit size. Besides, several novel structures are introduced to achieve higher performance, such as two pairs of twist modified split-ring resonators [8] and stepped impedance open-stub loaded ring resonator [9]. In this paper, a BPF based on two merged ring resonators with high selectivity is proposed, which is quite different from the BPF using ring resonators in [10]. Due to the symmetric structure of this proposed BPF, the distributions of six TZs can be calculated by odd-and even-mode method. The theoretical derivation of the proposed BPF is demonstrated. For validation, a BPF example centered at 2 GHz is fabricated and measured.

A High Selectivity Dual‐band Bandpass Filter Using Quadruple‐mode Multi‐stub Loaded Ring Resonator (SLRR)

A Tri-Band Filter Using Tri-Mode Stub-Loaded Resonators (Slrs)

High-Selective Bandpass Filters Based on New Dual-Mode Rectangular Strip Patch Resonators

A High Selectivity Quadruple-Mode Bpf with Two Short-Circuited Stub-Loaded Sirs

High-Selectivity Bandpass Filter Based on Two Merged Ring Resonators

Compact Dual-Band Differential Bandpass Filter Using Quadruple-Mode Stepped-Impedance Square Ring Loaded Resonators.

High Selectivity Wideband Bandpass Filter Based on Stepped Impedance Open Stubs Loaded Ring Resonator

Independently Controllable Dual-Band Microstrip Bandpass Filter Using Quadruple-Mode Stub-Loaded Resonator

High Selectivity Quadruple‐mode Broadband Bandpass Filter with Source‐load Coupling

Design of Quad-Band HTS Bandpass Filter Using Quadruple-Mode Square Ring Loaded Resonator

High-selectivity single-ended and balanced bandpass filters using ring resonators and coupled lines loaded with multiple stubs

Compact tri-band bandpass filter using short stud-loaded symmetric loop multimode resonator

A Quad‐band Bandpass Filter Using Split‐ring Based on T‐shaped Stub‐loaded Step‐impedance Resonators

DUAL-MODE BPF WITH FOUR TRANSMISSION ZEROS USING S-L COUPLING STRUCTURE WITH QUADRATIC FUNCTION COUPLING COEFFICIENT

A Triple-Mode Passband Filter With Improved Upper-Stopband Performance

Sharp-rejection dual ultra-wideband bandpass filter using sextuple mode resonator

A Dual-Band Bandpass Filter Using a Single Dual-Mode Ring Resonator

Design of Tri-Band Balanced Filter with Wideband Common-Mode Suppression and Upper Stopband Using Square Ring Loaded Resonator

Balanced tri- and quad-band BPFs based on SIR with improved passbands selectivity

A compact dual‐band bandpass filter based on coupled stub‐loaded square ring resonators by using transversal signal‐interaction concepts

High-selectivity wideband bandpass filter based on quintuple-mode stub-loaded resonator and defected ground structures