Abstract:This paper presents a flame retardant 4 (FR4)-based electromagnetic scanning micromirror, which aims to overcome the limitations of conventional microelectromechanical systems (MEMS) micromirrors for the large-aperture and low-frequency scanning applications. This micromirror is fabricated through a commercial printed circuit board (PCB) technology at a low cost and with a short process cycle, before an aluminum-coated silicon mirror plate with a large aperture is bonded on the FR4 platform to provide a high surface quality. In particular, an electromagnetic angle sensor is integrated to monitor the motion of the micromirror in real time. A prototype has been assembled and tested. The results show that the micromirror can reach the optical scan angle of 11.2 ∘ with a low driving voltage of only 425 mV at resonance (361.8 Hz). At the same time, the signal of the integrated angle sensor also shows good signal-to-noise ratio, linearity and sensitivity. Finally, the reliability of the FR4 based micro-mirror has been tested. The prototype successfully passes both shock and vibration tests. Furthermore, the results of the long-term mechanical cycling test (50 million cycles) suggest that the maximum variations of resonant frequency and scan angle are less than 0.3% and 6%, respectively. Therefore, this simple and robust micromirror has great potential in being useful in a number of optical microsystems, especially when large-aperture or low-frequency is required.

A 1×20 MEMS Mirror Array with Large Scan Angle and Low Driving Voltage for Optical Wavelength-Selective Switches

Novel MEMS Torsional Mirror Optical Switch

Multi-channel Optical Switching Based on Scanning Mirror Instrumentation

A 16×16 Micro Mirror Array for Optical Switches

Low-voltage Micromachining-Based Scalable Optical Switch

16×16 Mirror type optical switch with integrated fiber alignment and steady switching state

Research of an Adaptive Micro-Mirror Based on Micro-Opto-Electro-Mechanical- System

The Fabrication of 16*16 MEMS-Based Optical Switch with Accurate Optical Fiber Grooves Integration

Design of an Electrostatic Silicon Torsion Micromirror for Low Drive Voltage and Wide Angle MEMS Optical Switch Applications

Development of Novel Optical Switches Based on the MEMS Electromagnetic Micro-Actuator

A Three-Dimensional Micro-Electro-Mechanical System (MEMS) Optical Switch Module Using Low-Cost Highly Accurate Polymer Components

Symmetrical Design And Analysis Of A Novel Mems-Based 1x2 Optical Switch

Modeling and Optimization of a Novel ScAlN-Based MEMS Scanning Mirror with Large Static and Dynamic Two-Axis Tilting Angles

Novel optic-fiber switches based on the wobble-type MEMS electromagnetic microactuator

Turning-Mirror-Integrated Arrayed-Waveguide Gratings on Silicon-on-Insulator

FR4-Based Electromagnetic Scanning Micromirror Integrated with Angle Sensor

Fabrication and electromechanical characteristics of 2×2 torsion-mirror optical switch arrays with monolithically integrated fiber self-holding structures

An Improved Electrostatically-Driven Micro Torsion Mirror Fabricated by Silicon Micromachining for Optical Switching Devices

MEMS Scanning Mirror with Vertical Comb Actuator Based on Latching Technique

A Novel Variable Optical Attenuator Based on Micro-Electromechanical System (MEMS)

An optical switch array with 750μs switch time