Abstract:Light emitting diodes (LEDs) based on indium gallium nitride (InGaN) have been used widely in lighting applications and have shown great potential with high wall-plug efficiency and low manufacturing cost. However, one of the roadblocks in achieving higher light-extraction efficiency is total internal reflection, which prevents a majority of the photons from being extracted from the LEDs.The objective of this paper is to investigate measures for improving LED chip efficiency. Here, a high efficiency LED structure has been theoretically demonstrated using an infiltrated opal layer. A layer of indium-tin oxide (ITO) infiltrated opals was deposited on the surface of the LED chips as the light extraction layer in order to enhance the light extraction efficiency. Opals of similar radius periodically arranged on the structure will work as a rough surface. By enhancing the light extraction angle, the spontaneous emission from the active region can be emitted vertically. At the same time, opals with different radius and different refractive indexes are also studied. ITO, as the infiltration, is used to provide good lateral current spreading.The plane wave expansion (PWE), finite difference time domain,(FDTD), and rigorous coupled wave analysis (RCWA) methods are used to calculate the energy band structures and the extraction efficiency of the infiltrated opals layer. The scanning method and the Monte Carlo method are employed to optimize the structural parameters of the infiltrated opal layer. The infiltrated opals layer on the LED shows a high light extraction efficiency of over 60%.

The Improvement of Extractive Emission in InGaAlP Quantum Wells Light Emitting Diodes by Microstructures

Improvement of light extraction efficiency in AlGaInP-based vertical miniaturized-light-emitting diodes via surface texturing

Study on Structure Optimization of Strain-compensated InGaN-AlGaN Quantum Well Light-emitting Diode

Enhanced Light Extraction from a GaN-based Green Light-Emitting Diode with Hemicylindrical Linear Grating Structure.

Enhancement of Light Extraction from Microstructured GaN-Based Light Emitting Diodes by Technique of Nanoimprint

Improving AlGaInP Micro-LEDs Characteristics via Varied Dielectric Passivation Layers

Light Extraction Efficiency Improvement and Strain Relaxation in InGaN/GaN Multiple Quantum Well Nanopillars

Simulation of the Light Extraction Efficiency of Nanostructure Light-Emitting Diodes

Improvement of Micro-Led Top Emission Through Surface Nanostructures and Chip Design

New Progress in wafer epitaxy technologies for high-brightness white LEDs

Light Extraction Improvement from GaN-Based Light-Emitting Diodes with Nano-Patterned Surface Using Anodic Aluminum Oxide Template

Light Extraction Improvement of InGaN Light-Emitting Diodes with Large-Area Highly Ordered ITO Nanobowls Photonic Crystal Via Self-Assembled Nanosphere Lithography

Improvement of Light Extraction Efficiency in GaN-based Light-Emitting Diodes by Addition of Complex Photonic Crystal Structure

Enhancement of Light Extraction of GaN Light-Emitting Diode Using Opals Layer

Light extraction enhancement of light-emitting diodes by nanopillar hierarchical structures

Performance Enhancement of Ingan-Based Light-Emitting Diodes with Ingan/Alinn/Ingan Composition-Graded Barriers

Study on Light Extraction Efficiency of GaN-based Light-emitting Diode Chips

The Dependence of Light Extraction Improvement on Optimized Surface Microstructure for AlGaN-based UVC-LEDs Considering TM-polarized Emission

Improvement of the Emission Intensity of GaN-Based Micro-Light Emitting Diodes by a Suspended Structure

High-efficiency Near-Uv Light-Emitting Diodes on Si Substrates with InGaN/GaN/AlGaN/GaN Multiple Quantum Wells

Improving Light Extraction Efficiency of AlGaN-Based Deep Ultraviolet Light-Emitting Diodes by Combining Thinning P-Algan/p-gan Layer with Ni/Au/Al High-Reflectivity Electrodes