Abstract:Grains motion path will be changed in the point grinding process due to the existence of variable angle α. To verify the difference between point grinding and traditional grinding, the moving relationship and coordinate transformation between grinding wheel and workpiece are used to put the grain movement function equivalent to parabola, then point grinding cutting path is concluded. Based on grains distribution on the grinding wheel surface, the 3D geometry simulation topography of workpiece is obtained by extending the effective interference trails along the axial direction. Furthermore, a vitrified bond CBN wheel with a coarse grinding area angle θ is proposed and the principle of design and preparation of these novel grinding wheels are studied. The typical processing parameters are chosen to grind QT700 ladder shaft; the simulation results are verified by using the VHX-1000E microscope and the non-contact 3D surface profilometer to observe the workpiece surface topography and measure the surface roughness. The results indicated that the simulation microstructures coincide well with the experimental measurements and the values of simulation roughness are 0.5 times of experiments. So, the geometric simulation model provided an auxiliary and prediction method for the actual processing topography analysis. In addition, grinding wheels with different θ are used to grind ladder shafts with a series of grinding parameters. The influence trend of inclining angle α , cutting depth a p , axial feeding speed v f and grinding wheel speed v s on surface roughness is obtained. It is concluded that the values of workpiece surface roughness using novel grinding wheel are less than using the traditional grinding wheel under the condition of the same processing parameters.

Study on nodular cast iron surface topography and abrasive wear in ultrasonic vibration assisted grinding

Effect of Ultrasonic Vibration Assisted Grinding Process on Surface Topography and Properties of C/SiC Composite

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Study on Surface Creation Law of Planar Two-Dimensional Ultrasonic-Assisted Abrasive Belt Grinding

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Theoretical and Experimental Investigations of Surface Generation Induced by Ultrasonic Assisted Grinding

Abrasive Wear of a Single CBN Grain in Ultrasonic-Assisted High-Speed Grinding

Investigation of Surface Topography Formation Mechanism Based on Abrasive-Workpiece Contact Rate Model in Tangential Ultrasonic Vibration-Assisted CBN Grinding of ZrO2 Ceramics

Study on Critical Ductile Grinding Depth of Nano Zro2 Ceramics by the Aid of Ultrasonic Vibration

The axial ultrasonic vibration single trajectory and CBN grits cutting force experiment research

Study on grinding performance during ultrasonic vibration-assisted grinding ultra-high strength steels

Study on Ductile Grinding Character of Nano ZrO2 Ceramics using Ultrasonic Vibration Grinding

Establishment of dynamic grinding force model for ultrasonic-assisted single abrasive high-speed grinding

Research on Simulation and Experiment for Surface Topography Machined by A Novel Point Grinding Wheel

Study on Ultrasonic Vibration Assisted Grinding in Theory

Surface roughness model of ultrasonic vibration-assisted grinding GCr15SiMn bearing steel and surface topography evaluation

Evaluation of Abrasive Layer Optimization of Grinding Wheel and Its Surface Topography after Super High-Speed Point Grinding

Experimental Study on Ultrasonic Vibration Assisted Grinding of GCr15SiMn Bearing Steel

Mechanism and Experimental Evaluation on Surface Morphology of GCr15SiMn with Ultrasonic Vibration Grinding

Study On The Surface Quality Of Silicon Nitride Ceramics In Ultrasonic Vibration Grinding

Study on surface quality of nano ZrO2 ceramics in grinding by the aid of ultrasonic vibration