Abstract:AISI 9310 steel has garnered increasing attention for its superior mechanical properties in the manufacturing of transmission gears for helicopters and accessory transmission systems in aero-engines. The ultrasonic vibrationassisted grinding (UVAG) technique is a new potential method to machine tooth surface given the periodically changing trajectory between abrasive grains and the workpiece, contributing to enhancing heat transfer and thus solving sudden burns. The accurate prediction of grinding heat and the proposal of the associated control strategy are desired to ensure the machining quality. Combined with the separation coefficient model and the chip volume distribution of UVAG processes, a new moment-triangle (MT) heat source model was established. Subsequently, comparative analyses on grinding temperature with conventional grinding and UVAG process were performed using the conditional triangular heat source model and the proposed MT heat source model. Results show that the MT heat source model has a lower prediction error with an average error of 7.13%, which is improved by 7.33% compared with that of the triangular heat source model. The prediction accuracy for the maximum grinding temperature can be raised by 13.39% when the MT heat source model is applied in place of the other one under UVAG processes. In addition, the heat source model transits from triangular into uniform heat source gradually as the ultrasonic amplitude increases, and the transition rate is positively correlated with the ultrasonic amplitude. On this basis, the desired controlling strategy is proposed to enhance the machining performance of ultrasonic grinding processes and effectively reduce heat generations during grinding by increasing the ultrasonic amplitude, reducing the depth of cut and decreasing the workpiece speed.

Experimental Study on Ultrasonic Vibration-Assisted Grinding of Hardened Steel Using White Corundum Wheel

Wear Characteristics of White Corundum Abrasive Wheel in Ultrasonic Vibration-Assisted Grinding of AISI 9310 Steel

On the Grinding Performance of Alumina Wheels in Ultrasonic Vibration–assisted Grinding of Hardened GCr15 Steel

Study on grinding performance during ultrasonic vibration-assisted grinding ultra-high strength steels

Experimental Study on Ultrasonic Vibration Assisted Grinding of GCr15SiMn Bearing Steel

Effect of Ultrasonic Vibration Assisted Grinding Process on Surface Topography and Properties of C/SiC Composite

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Study on the system matching of ultrasonic vibration assisted grinding for hard and brittle materials processing

An experimental investigation of system matching in ultrasonic vibration assisted grinding for titanium

On the Tool Wear Behavior During Ultrasonic Vibration-Assisted Form Grinding with Alumina Wheels

Mechanism and Experimental Evaluation on Surface Morphology of GCr15SiMn with Ultrasonic Vibration Grinding

Wear behavior of white alumina and seeded gel abrasive wheels in ultrasonic vibration-assisted grinding of nickel-based single-crystal alloy

MOPSO Process Parameter Optimization in Ultrasonic Vibration-Assisted Grinding of Hardened Steel

Experimental Investigation of Ultrasonic Vibration-Assisted Grinding of HVOF-Sprayed WC-10Co-4Cr Coating

Experimental Research On Ultrasonic Torsional Vibration-Assisted Grinding Of Hard And Brittle Materials

Study on nodular cast iron surface topography and abrasive wear in ultrasonic vibration assisted grinding

Thermal Analysis of Ultrasonic Vibration-Assisted Grinding with Moment-Triangle Heat Sources

Surface roughness model of ultrasonic vibration-assisted grinding GCr15SiMn bearing steel and surface topography evaluation

Investigation of the grinding temperature and subsurface quality of a novel point grinding wheel

Improved wear resistance of 440 C steel ball via ultrasonic strengthening grinding process

Investigation of the wear characteristics of microcrystal alumina abrasive wheels during the ultrasonic vibration-assisted grinding of PTMCs