Experimental Study on the Effect of Grinding Path in Tangential Ultrasonic-Assisted Grinding for the Curved Surfaces of Zirconia Ceramics
Southern University of Science and Technology,Feng Ming,Wu Hanqiang,Li Sisi,Zeng Jiang,Wu Yongbo
DOI: https://doi.org/10.1007/s00170-021-08077-0
IF: 3.563
2021-01-01
The International Journal of Advanced Manufacturing Technology
Abstract:Parts made of zirconia ceramics have been used in various high-end fields, and some of these parts exhibit complex styles with various curved surfaces. As a prominent machining technique for manufacturing zirconia ceramic parts, tangential ultrasonic-assisted grinding has mainly been employed in improving the processing efficiency and simultaneously ensuring the surface quality. With the aim of further improving the processing performance of tangential ultrasonic-assisted curved surface grinding, the effects of the grinding paths with α = 0°, α = 45°, and α = 90° on the surface quality and profile of a workpiece were studied for a specific curved surface, and the wear of the grinding wheel with different paths was analyzed. In addition, the material removal mechanisms were discussed for single diamond grit grinding tests. The obtained results demonstrated that (1) the surface roughness Sa was different at different grinding paths, i.e., at different values of α, and the surface finish mainly depended on the ultrasonic amplitude. (2) The profile error of the curved work-surface was different at different values of α. (3) The wear of the grinding wheel at α = 45° was the most serious, and at α = 0° and α = 90°, the abrasive grain wear was slight. These tendencies agreed with the case of the work-surface quality. (4) The material removal mechanism was different with and without ultrasonics, which resulted in the differences in the work-surface finish.