Abstract:A novel type of microcavity organic light-emitting diode based on a porous silicon distributed Bragg reflector (PS-DBR) has first been achieved and its microstructure, optical, and electrical properties have also been investigated in detail. The microcavity is made up of the central active organic multilayer sandwiched between a top silver film and a bottom PS-DBR, formed by electrochemical etching of p ++ -Si substrate. The fieldemission scanning electron microscopy cross-section images show the nanometer-scale layered structure and flat interfaces inside the microcavity. The reflectivity (relative to an Al mirror) of the PS-DBR is up to 99%, and the stopband is about 160 nm wide. Resonant cavity mode appears as a tip in the reflectivity spectrum of the Si-based organic multilayer films, which is a symbol that the Si-based organic multilayer structure is indeed a microcavity. The peak widths of the electroluminescence (EL) spectra from the cavities emitting green and red light are greatly reduced from 85 nm and 70 nm to 8 nm and 12 nm, respectively, as compared with those measured from non-cavity structures. Note that the EL emission from the cavity devices is single-mode, and the off-resonant optical modes are highly suppressed. Moreover, increases of a factor of about 6 and 4 of the resonant peak intensity from the cavities emitting green and red light are also observed, respectively. In addition, the current-brightness-voltage characteristics and effect parameters on the lifetime of the cavity devices are also discussed. The present technique for obtaining enhanced EL emission from Si-based organic microcavity may also be another novel effective method for realizing Si-based optoelectronics device integration.

Study on the Enhancement of Organic Semiconducting Microcavity Light Emitting Devices

Optical Properties of Unsymmetrical Metal Microcavity in Organic Luminescent Devices

Study of Organic Electrolumenescent Thin Film Cell

Optical trait of unsymmetrical metal microcavity in organic thin film luminescent devices

Microcavity of Organic Semiconductor

Investigation of Energy Transfer and Charge Trapping in Dye-Doped Organic Light-Emitting Diodes by Magneto-Electroluminescence Measurement

Enhanced Chromaticity of Organic Electroluminescence from Silicon-Based Organic Microcavity

Study on the Influence of Embedded Structure of Carbon Quantum Dots of the Organic Solar Cells with the Territory Active Layer Structure of P3HT: PC61BM: CQDs

Studies on the Microstructure, Optical and Electrical Properties of Organic Microcavity Devices Based on a Porous Silicon Reflector

Study on Microcavity Organic Light-emitting Devices Containing Negative Refractive Index Dielectric Layer

High-efficiency Red Phosphorescent Organic Light-Emitting Diodes Based on Metal-Microcavity Structure

Construction and evaluation of organic electroluminescent devices

Structure and electroluminescence characteristics of organic thin film electroluminescent devices

Influence of Sensitizer on Organic Electroluminescence

Improvement in Performance of Organic Light-Emitting Diodes by Adjusting Charge-Carrier Mobility in Organic/inorganic Hybrid Hole Transporting Layer

Organic Electroluminescent Device Based on Balanced Carriers Injection and Transportation

Single-layer Small Molecular Organic Light Emitting Diodes Without Hole Transport Layer

Enhanced Hole Injection in a Bilayer Vacuum-Deposited Organic Light-Emitting Device Using a P-Type Doped Silicon Anode

Highly efficient and bright doped organic electroluminescent diodes using an aluminum electrode

High Luminance Organic Light-Emitting Diodes with Efficient Multi-Walled Carbon Nanotube Hole Injectors

Blue polymer light-emitting diodes with organic/inorganic hybrid composite as hole transporting layer