Equiaxed Ti-based Composites with High Strength and Large Plasticity Prepared by Sintering and Crystallizing Amorphous Powder
L. H. Liu,C. Yang,L. M. Kang,Y. Long,Z. Y. Xiao,P. J. Li,L. C. Zhang
DOI: https://doi.org/10.1016/j.msea.2015.10.048
IF: 6.044
2016-01-01
Materials Science and Engineering A
Abstract:High-performance titanium alloys with an equiaxed composite microstructure were achieved by sintering and crystallizing amorphous powder. By introducing a second phase in a β-Ti matrix, series of optimized Ti–Nb–Fe–Co–Al and Ti–Nb–Cu–Ni–Al composites, which have a microstructure composed of ultrafine-grained and equiaxed CoTi2 or (Cu,Ni)Ti2 precipitated phases surrounded by a ductile β-Ti matrix, were fabricated by sintering and crystallizing mechanically alloyed amorphous powder. The as-fabricated composites exhibit ultra-high ultimate compressive strength of 2585MPa and extremely large compressive plastic strain of around 40%, which are greater than the corresponding ones for most titanium alloys. In contrast, the alloy fabricated by sintering and crystallizing Ti–Zr–Cu–Ni–Al amorphous powder, which possesses significantly higher glass forming ability in comparison with the Ti–Nb–Fe–Co–Al and Ti–Nb–Cu–Ni–Al alloy systems, exhibits a complex microstructure with several intermetallic compounds and a typical brittle fracture feature. The deformation behavior and fracture mechanism indicate that the ultrahigh compressive strength and large plasticity of the as-fabricated equiaxed composites is induced by dislocations pinning effect of the CoTi2 or (Cu,Ni)Ti2 second phases and the interaction and multiplication of generated shear bands in the ductile β-Ti matrix, respectively. The results obtained provide basis guidelines for designing and fabricating titanium alloys with excellent mechanical properties by powder metallurgy.