The comparison of TF Nickle-Titanium instruments with different operation mode in the preparation of curved root canal of molars

Xing-chen WU,Xiao-jie WANG,Ya-qin ZHU
DOI: https://doi.org/10.15956/j.cnki.chin.j.conserv.dent.2015.08.005
2015-01-01
Abstract:AIM:To evaluate the endodontic preparation ability of single TF nickel-titanium instrument with different operation mode in the preparation of curved root canal. METHODS:90 intact molars with 105 root canals were divided into 3 groups(n=30 molars with 35canals), the canals of the molars were prepared by the instrument with continuous rotation at 500 r/min( group A ) ,reciprocating movement at 300 r/min ( group B ) and continuous rota-tion at 300 r/min( group C ) respectively . The CBCT images of the root canal sections were recorded, the root transpor-tation and centering ratio were measured before and after instrumentation. The preparation time, wearing and tearing degree of the instrument were compared. RESULTS:At 3. 0 mm from the anatomic apex, root transportation of group B was significantly greater than that of group A (P<0. 05), centering ratio of group C was significantly better than that of group B (P<0. 05). There was no significant difference in root transportation and centering ratio among 3 groups at the distances of 1. 5 mm and 6 mm from the anatomic apex. The preparation time of group B was significantly longer than that of group A and C (P<0. 05). The lifespan of group B was about 2 times of group A and C. CONCLU-SION:TF single nickel-titanium instrument(#25/06) used with reciprocating mode may produce lower efficiency but higher security. When it is used with continues rotation mode, there is no significant difference between the speeds of 300 r/min and 500 r/min except that the speed of 300 r/min may shorten the lifespan of the instrument.
What problem does this paper attempt to address?