Abstract:By pulsed laser deposition (PLD) method ferroelectric BaTiO3 nanofilms were grown on Si substrates coated by nanoporous alumina membranes (NAMs) with an average pore size of 20 nm,and metal Pt nanowires were embedded in NAMs as a part of the bottom electrode. The dielectric and ferroelectric properties,and microstructure of the BaTiO3 nanofilms were characterized. The results showed that the dielectric constant of the BaTiO3 nanofilms with a thickness of 170 nm,decreased slowly from 400 to 350 as the measured frequency was increased from 103 Hz to 106 Hz,and that the dielectric loss increased slowly from 0.029 to 0.036 in the low frequency range from 103 Hz to 105 Hz,whereas quickly increased up to 0.07 at high frequencies over 105 Hz. Such a phenomenon was resulted from the dielectric dipolar polarization in the BaTiO3 nanofilms. Polarization-electric field hysteresis loop indicated that the remanent polarization and the coercive field of the BaTiO3 nanofilms were 17 μC/cm2 and 175 kV/cm,respectively. Cross-sectional (scanning) transmission electron microscopy (TEM) images demonstrated that the BaTiO3 nanofilms contacted directly with the Pt nanowires,and the interface between them had some degree of waviness. Both selected area electron diffraction and high-resolution TEM images confirmed that the BaTiO3 nanofilms were the tetragonal phase with a perovskite structure. After post-annealing and crystallization of the BaTiO3 nanofilms,some Pt nanowires became branches at their ends due to the re-growth of the Pt nanowires. A suitable post-annealing temperature is the critical processing parameter of fabricating ferroelectric ordered nanostructures as considering a trade-off between the ordered metal nanowires within NAMs and the crystallinity of ferroelectric nanofilms.

Synthesis and Properties of Ce3+ Doped Barium Titanate Nanotube Thin Films

Low Temperature Hydrothermal Synthesis and Performances of Nanotube Patterned Barium Titanates Thin Films

Hydrothermal Synthesis of Tetragonal BaTiO3 Nanotube Arrays with High Dielectric Performance

Electrophoretic Deposition and Photoluminescent Properties of Eu-doped BaTiO3thin Film from a Suspension of Monodispersed Nanocrystallites

Preparation of A Monodispersed Suspension of Barium Titanate Nanoparticles and Electrophoretic Deposition of Thin Films

Low-temperature synthesis of barium titanate thin films by nanoparticles electrophoretic deposition

Preparation of Nano-Structured BaTiO3 Thin Film by Electrophoretic Deposition and Its Characterization

Study on Hydrothermal Synthesis and Performances of Thin Film Barium Titanate Ceramic Nano-tubes

Investigation of local structure and phase transformation in Ce-doped barium titanate and correlation with electrical properties

Synthesis, Characterization and Electrical Properties of Barium Titanate Films Fabricated by Hydrothermal Method

Hydrothermal Synthesis Of Thin Films Of Barium Titanate Nanotube Arrays

Fabrication, physical property and microstructural characterization of ferroelectric BaTiO3 nanofilms

Optical Properties of Bi3.15nd0.85ti3o12 Nanostructures

Synthesis of Thin Films of Barium Titanate and Barium Strontium Titanate Nanotubes on Titanium Substrates

Structural and Dielectric Properties of Nickel-Doped and Lanthanum-Chromium-Doped Barium Titanate Ceramics

Experimental and Simulation-Based Understanding of Morphology Controlled Barium Titanate Nanoparticles under Co-Adsorption of Surfactants

Composition-Dependent Structures And Properties Of (1-X)Batio3-Xnanbo(3) Thin Films

Structure study of single crystal BaTiO3 nanotube arrays produced by the hydrothermal method.

Chemical design of barium titanate thin films for nanophotonic devices

Morphology and atomic-scale surface structure of barium titanate nanocrystals formed at hydrothermal conditions

Dielectric and structural studies of ferroelectric phase evolution in dipole pair substituted barium titanate ceramics