Abstract:Recent years have witnessed an increasing use of high strength aluminium alloys in structural applications, however, the mechanical properties of this type of materials are rather susceptible to elevated temperatures. This paper presents an experimental study on the mechanical properties of 7A04-T6 high strength aluminium alloy at elevated temperatures and after cooling down. Tensile coupon tests were first carried out on the specimens at high-temperature steady state conditions and post-fire conditions for temperatures ranging from 20 to 400 °C. The effect of cooling methods (cooled by air/water) was taken into account in the post-fire tests. Key mechanical properties, including Young’s modulus, yield strength, ultimate strength and ultimate strain, as well as the stress–strain responses obtained from both tests were fully reported and the microstructures of the post-fire material were examined. It is shown that the Young’s modulus and strengths decrease dramatically when temperatures are higher than 200 °C and the strengths decrease to less than 5% of the room temperature values at 400 °C, but a large proportion (up to 90%) of them regains after cooling down. In addition, the post-fire mechanical properties of the material exposed to 400 °C was found to be higher than those exposed to 300 °C; this was further explained through the microstructure examination. The test data were then utilised to assess the accuracy of existing codified design methods and the comparisons revealed that all of them provide inaccurate and scattered predictions. Finally, design formulae for the elevated-temperature retention factors as well as the post-fire residual factors and a two-stage Ramberg–Osgood material model were proposed. The design proposal was found to provide accurate predictions for the full-range stress–strain responses of the high strength aluminium alloy at both high-temperature steady state and post-fire conditions.

Research on the mechanical properties of 2099 aluminum-lithium alloy profile at hot forming temperature

Mechanisms and microstructures of 2A97 Al-Li alloy under the hot forming with synchronous quenching process

Investigation of formability of aluminum alloy sheet at elevated temperature

Hot Deformation Behavior and Processing Maps of 2099 Al-Li Alloy

The Study on Forming Property at High Temperature and Processing Map of 2219 Aluminum Alloy

Hot Workability of a Spray Formed 2195 Aluminum-Lithium Alloy Based on an Improved Isothermal Processing Map and Drx ‘C-Curve’

Analysis of hot Formability of Al-4.6Mg-0.6Mn Alloy (AA5083)

Formability Evaluation of Aluminum Alloy 6061-T6 Sheet at Room and Elevated Temperatures

Investigation on hot deformation behavior of 2050 Al-Cu-Li alloy

Hot Workability and Microstructure Evolution of Homogenized 2050 Al-Cu-Li Alloy during Hot Deformation

Research on High-Temperature Constitutive Relationship of Aluminum Alloy

Characterization and constitutive analysis-based crystal plasticity of warm flow and fracture behaviours of 2060 Al-Cu-Li alloy

Study on Mechanical Properties and Constitutive Model of 5052 Aluminium Alloy

Hot compressive deformation behavior and microstructural evolution of the spray-formed 1420 Al–Li alloy

Effect of Temperature on Superplastic Deformation Behavior of 2198 Al–Cu–Li Alloy

Mechanical properties of 7A04-T6 high strength structural aluminium alloy at elevated temperatures and after cooling down

Constitutive behavior and novel characterization of hot deformation of Al-Zn-Mg-Cu aluminum alloy for lightweight traffic

Analysis of Constitutive Behaviours and Processing Map of 7020 Aluminium Alloy

Hot Deformation Behavior and Microstructural Evolution of a New Type of 7xxx Al Alloy

M–K model based forming limit prediction of aluminum–lithium alloy 2060 and its application in hot stamping

Unified Constitutive Model of Aluminum Alloy 2219 at Elevated Temperature