Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Radial forging force and spread for rectangular cross-sectional forging

Effects of Process Parameters on FPE in Radial Forging Processes

An Upper Bound Solution of Forging Load in Cold Radial Forging Process of Rectangular Cross-Section Billet

Multi-objective optimization of concave radial forging process parameters based on response surface methodology and genetic algorithm

Numerical optimization on hot forging process of connecting rods based on RSA with experimental verification

An Upper Bound Solution of Axial Metal Flow in Cold Radial Forging Process of Rods

Multi-objective optimization of forging surface structure parameters of radial forging die with cycloidal

STUDY ON THE NUMERICAL SIMULATION OF MULTI-STAGE ROTARY FORGING OF A NON-AXISYMMETRIC PART AND THE CAE ANALYSIS OF THE DIE STRENGTH

Numerical Simulation of Chamfering and Rounding Process of Heavy Forgings under Different Anvils

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

Numerical Simulation of Pre-forging for Connecting Rod of Automobile Engine and Optimization of Its Pre-forging Billet

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

3D FE modeling simulation of the double-roll hot rotary forging of large diameter thin-walled metal disk

Improvement of Axial Forging Process for Spline Shaft by Die Design

The derivation and validation of a formula calculating the forging penetration efficiency (FPE) based on empirical method

Defect analysis and design optimization on the hot forging of automotive balance shaft based on 3D and 2D simulations

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

Application and Development of Radial Forging Technology

Upper Bound Analysis of Forging Penetration in a Radial Forging Process

A Novel Method for Determining Friction in Cold Forging of Complex Parts Using a Steady Combined Forward and Backward Extrusion Test

Upper Bound Analysis of Axial Metal Flow Inhomogeneity in Radial Forging Process