Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Upper Bound Analysis of Forging Penetration in a Radial Forging Process

An Upper Bound Model with Continuous Velocity Field for Strain Inhomogeneity Analysis in Radial Forging Process

Upper Bound Analysis of Axial Metal Flow Inhomogeneity in Radial Forging Process

An Upper Bound Solution of Forging Load in Cold Radial Forging Process of Rectangular Cross-Section Billet

An Upper Bound Solution of Axial Metal Flow in Cold Radial Forging Process of Rods

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

An analysis for three-dimensional upset forging of elliptical disks and rings based on the upper-bound method

Effects of Process Parameters on FPE in Radial Forging Processes

The derivation and validation of a formula calculating the forging penetration efficiency (FPE) based on empirical method

Radial forging force and spread for rectangular cross-sectional forging

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

Numerical Simulation for Forging Process of Bearing Rings

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

A Pass Planning Method for Multi-Hit Stretching of Heavy Forgings by Integration of a Semi-Analytical Technique and Degrees-Reduced Finite Element

Pass Schedule Design For Flat-Tool Forging Based On Upper Bound Analysis

Prediction and Analysis of Breakthrough Extruding Force Based on a Modified FE-model in Large-Scale Extrusion Process

Two Step Forging Process of Spur Gear Based on Rigid Parallel Motion

A New Approach to Precision Cropping with Radial Forging

Simulation of cylindrical up setting of porous materials by finite element method

Computer Modeling of Property-controlled Forging Process for Heavy Forgings

Numerical Simulation of Chamfering and Rounding Process of Heavy Forgings under Different Anvils