Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

The derivation and validation of a formula calculating the forging penetration efficiency (FPE) based on empirical method

Effects of Process Parameters on FPE in Radial Forging Processes

Application of FEM Simulation to the Effects of Working Parameters on Isothermal Forging of 7075 Aluminum Alloy

Numerical Simulation of Pre-forging for Connecting Rod of Automobile Engine and Optimization of Its Pre-forging Billet

Radial forging force and spread for rectangular cross-sectional forging

Numerical Simulation of Chamfering and Rounding Process of Heavy Forgings under Different Anvils

Upper Bound Analysis of Forging Penetration in a Radial Forging Process

Numerical Simulation for Forging Process of Bearing Rings

3D FEM simulation of multi-stage forging process using solid modeling of forging tools

STUDY ON THE NUMERICAL SIMULATION OF MULTI-STAGE ROTARY FORGING OF A NON-AXISYMMETRIC PART AND THE CAE ANALYSIS OF THE DIE STRENGTH

Prediction of Deformation Behavior and Microstructure Evolution in Heavy Forging by FEM

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

A Pass Planning Method for Multi-Hit Stretching of Heavy Forgings by Integration of a Semi-Analytical Technique and Degrees-Reduced Finite Element

Multi-objective optimization of concave radial forging process parameters based on response surface methodology and genetic algorithm

Billets Study During Piston Skirt Forging Process of LD11 Aluminium Alloy

Forging process and FEM optimization for forged knuckles of railway wagons

Analysis of Die Forging Process and FEA of Piston

Finite element simulation of isothermal forging of complex component using constitutive relationship of 7A04 alloy

Improving the Deformation Uniformity Within Forgings by Applying Preformed Optimization Based on FEM

3D FEM simulation of isothermal forging process for TC11 titanium alloy impeller

Numerical optimization on hot forging process of connecting rods based on RSA with experimental verification