Abstract:Purpose – The purpose of this paper is to build a flow stress model and microstructure evolution models which can be used to fulfill the multi-physics prediction of hot forging process, in this way the process design can be virtually verified and optimized. This is especially crucial for micro-alloyed steel forging which microstructure determines the component properties, since the downstream quenching is usually not needed. Design/methodology/approach – First, hot compression tests have been completed; second, experimental data are used to build the flow stress model and models for microstructure evolution; third, programming has been finished to integrate the proposed models into the commercial finite element method (FEM) code; fourth, case study is conducted to simulate multi-stage hot forging process of micro-alloyed steel F38MnV piston; and fifth, simulation results are validated by experiment. Findings – First, simulation results in grain size and phase volume fraction are in well agreement with experimental ones; second, the austenite grain is dramatically refined by the dynamic recrystallization in pre-forging process and static recrystallization in the two intervals has no obvious change during the following final forging and cooling above the Ae3 temperature; third, during the cooling process below the Ae3 temperature, ferrite and pearlite transformation begin from the thin skirt to the thick skirt and piston bottom because of different cooling speeds at different areas. Originality/value – First, flow stress model, dynamic recrystallization model, static recrystallization model, austenite grain growth model and phase transformation models are established for a micro-alloyed steel; second, the multi-physics FEM simulation of multi-stage hot forging of industrial piston has been conducted and verified by experiment, which show good agreement.

Prediction of Deformation Behavior and Microstructure Evolution in Heavy Forging by FEM

Simulation and Analysis of Microstructure Evolution of IN718 in Rotary Forgings by FEM

Numerical Prediction on Microstructure Evolution for Multi-Stage Hot Forging of Micro-Alloyed Piston

A Novel Unified Model Predicting Flow Stress and Grain Size Evolutions During Hot Working of Non-Uniform As-Cast 42crmo Billets

Numerical Simulation of GH4169 Alloy Disc Forging Process on Counterblow Hammer

Finite Element Analysis of Repeated Forging Severe Plastic Deformation

A Numerical Simulation of Microstructure Evolution of IN718 Alloy During Multi-step Forging

Computer Modeling of Property-controlled Forging Process for Heavy Forgings

Prediction of microstructure evolution of Al–1% Mg alloy during hot forming and sequential heat treatment

3D FEM simulation of multi-stage forging process using solid modeling of forging tools

Numerical simulation of microstructure evolution of flange axle during hot forging

Research on the stress and strain evolution of aluminum alloy hot forging die

Numerical simulation and experimental validation of microstructure evolution during the upsetting process of a large size martensitic stainless steel forging

Effects Of Forging Process Parameters On Microstructuire Evolution Of Alloy 7050

Numerical Simulation of Process and Grain Size for Large-Sized Aluminum Alloy 7050 Forging

Microstructure evolution modelling of heavy forging steel 30Cr2Ni4MoV during hot deformation

Prediction of Microstructural Evolution During Hot Forging

Numerical Prediction of Microstructure and Mechanical Properties During the Hot Stamping Process

Experimental and Finite Element Analysis of Flow Behavior of 2A14 Aluminum Alloy During Multi-directional Forging

Dynamic modeling for forging system considering plastic deformation of workpiece

Coupled Analysis and Application of Deformation Models in a Disk Forging Process