Abstract:Due to the tool-workpiece separation effect, high-speed ultrasonic vibration cutting has the proven ability to reduce tool flank wear and prolong tool life by up to approximately three times when turning Ti-6Al-4V alloys in the recent research. Temperature reduction caused by the cooling medium penetrating into the gaps of the tool-workpiece contact zone is considered to be the primary reason for this remarkable performance. In this paper, a tool-workpiece thermocouple system was developed for the temperature measurement of high-speed ultrasonic vibration cutting Ti-6Al-4V alloys. First, the calibration of the tool-workpiece thermocouple was conducted to identify the piecewise linear relation between thermoelectric power and cutting temperature. Next, the insulation of the thermoelectric circuit from both the vibration-stimulated circuit and the experiment platform was realized. Finally, comparative cutting experiments on high-speed ultrasonic vibration cutting and conventional cutting with and without cutting fluid were carried out. The experimental results demonstrate that in the dry cutting experiments, no obvious temperature difference between these two methods occurred. However, when cutting fluid was applied, compared to conventional cutting, a maximum 30% temperature reduction could be realized by high-speed ultrasonic vibration cutting with a duty cycle value of 0.55 at cutting speeds of 250 to 300 m/min. Therefore, cutting fluid is thought to be an essential part of effective cooling in the process of high-speed ultrasonic vibration cutting and its cooling behavior during such a short separation interval needs further researches.

VACUUM BRAZING OF ULTRASONIC CUTTING TOOL

Effects of ultrasonic vibrations on brazing mechanism and evaluating grinding performance of CBN tools

Welding method of copper target blank and copper alloy backing plate

The use of acousto-ultrasonics to determine the quality of the brazing of carbide-tipped cutting tools

Ultrasonic Elliptical Vibration Texturing of the Rake Face of Carbide Cutting Tools for Adhesion Reduction

Impact of ultrasonic vibration on microstructure and mechanical properties of diamond in laser brazing with Ni–Cr filler alloy

Design of ultrasonic elliptical vibration cutting system for tungsten heavy alloy

Recent development of ultrasonic brazing

Study on Ultra-Precision Processing of Ti-6Al-4V with Different Ultrasonic Vibration-Assisted Cutting Modes

Development of a tool-workpiece thermocouple system for comparative study of the cutting temperature when high-speed ultrasonic vibration cutting Ti-6Al-4V alloys with and without cutting fluids

A high-strength vacuum brazed TC4/316L joint with a Ti–Zr-based amorphous ribbon as the filler metal

Vacuum Brazing of C/C Composite and TiAl Intermetallic Alloy Using BNi-2 Brazing Filler Metal

Vacuum Brazing of Carbon Nanotube Bundles

Study on the Material Removal Mechanism of Ultrasonic Elliptical Vibration Cutting of Medical β Titanium Alloy

Thermal-fluid-solid coupling analysis of vacuum brazing process for a titanium alloy plate-fin structure

Vacuum brazing TiAl intermetallics to GH3030 alloy with a multi-component Ti-based filler metal

Microstructure and Mechanical Properties of Ti-Based Amorphous Solder Vacuum Brazing Joint for Stainless Steel

Interfacial microstructure and mechanical properties of WC–Co/40Cr joints brazed at low–temperature with Ag–Cu–Ti + Sn novel filler

Microstructures and mechanical properties of YG18 cemented carbide/40Cr steel joints vacuum brazed using Ag–Cu–Ti filler metal

Ultrasonic Vibration Cutting of Stainless Steel with Polycrystalline Diamond Tools

Ultrasonic Vibration-Assisted Cutting of AISI 420 Mod Steel by Using CVD Thick-Film Diamond Tool