Abstract:Process-induced deformation in composite laminates usually occurs during the curing process and is strongly dependent on the cure parameters. To study the influence of the cure parameters on the warpage deformation, an experimental study was carried out with different heating rates and first dwell times. The full-field process-induced deformation was captured by contactless 3 D scanning system to validate the numerical method. Second, a multi-scale thermo-viscoelastic modeling technique was employed to predict the process-induced deformation. The results showed a good agreement between the simulation and experimental deformation, which demonstrates the effectiveness of the numerical model. The influence of six different cure parameters of the vacuum bagging process on the warping deformation and residual stress were considered in the numerical study. Knee points were found on the curves depicting the influence of cure parameters on the maximum residual deformation. Within the manufacturer’s specified range, a slower heating rate of 1.5°C/min reduced the process-induced deformation by 7%, while the other parameters affected the process-induced deformation by less than 1.4%. Meanwhile, the residual stress was also reduced with a slower heating rate. Consequently, a lower heating rate is suggested to reduce both the process-induced deformation and the residual stress for thin parts or the zero-bleeding process.

The Influence of Linear Shrinkage on Curl Distortion in SL

Study on the Effect of Photocuring Resin Shrinkage on Parts Curl Distortion in the Process of Laser Rapid Prototyping

RESEARCH ON RELATION OF TIME-EFFECT WITH PARTS'CURL DISTORTION IN STEREOLITHOGRAPHY

Investigation of the Part Deformation in Stereolithography

Model of Shrinking and Curl Distortion for SLS Prototype S

Shrinkage Effects in Photopolymerizable Resin containing Polymer Filler for SL

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

Investigation on Shrinkage of Parts Made by SLS

Analysis of the part deformation in stereo-lithography based on FEA

Influence of Degree of Cure and Cure Shrinkage on the Finial Deformation of the Unsymmetric Composite Laminates

Volume Shrinkage of UV-curable Coating Formulation Investigated by Real-Time Laser Reflection Method

Effect of Dynamic Injection Molding Process Parameters on Shrinkage of Parts

Design for the reduction of volume shrinkage-induced distortion in digital light processing 3D printing

Experiment on the Shrinkable Character of Material DuringConvective Drying Process

Comparative Study on the Effect of Cure Parameters on Residual Deformation for Thermoset Composite Laminates

Research on a Low Curl Photocurable Resin for Stereolithography

Inverse Identification of In-Situ Curing Shrinkage Using a Method Combining 3D Digital Image Correlation and Finite-Element Simulation

Effect of Monomer Structure on Real‐Time UV‐Curing Shrinkage Studied by a Laser Scanning Approach

The Propagation and Accumulation of Dimensional Shrinkage for Ring-to-ring Structure in Investment Casting

Shrinkage Behavior Influence Of Strain-Hardening Cementitious Composites

Numerical Model and Experimental Validation for Laser Sinterable Semi-Crystalline Polymer: Shrinkage and Warping