Abstract:When single-phase earth fault occurs in neutral non-effectively earthed system,there are remarkable differences between transient signal of faulty phase and that of non-faulty phases in energy-concentrated frequency bands and signal amplitudes,the fault signal of faulty phase possesses high amplitude and the energy is concentered in low frequency band,however for non-faulty phase the conditions are just the opposite.On this basis a two-dimensional fault line detection method,which was based on the transient signal energy and centroid frequency of faulty phase,was proposed.The overall distribution characteristic of transient fault signal in frequency domain,which is included in the creteria of two-dimensional fault line detection,was used to detect the faulty line,in view of the fact that the two-dimensional creteria were complementary each other,the reliability of faulty line detection was evidently enhanced.The proposed method was suitable to distribution network only possessing overhead feeders and hybrid distribution network where the cable outlet existed,and was suitable to ungrounded neutral system and resonant earthed neutral system.Besides,the proposed method was effective for both conditions: the initial phase angle was 0? at the moment the fault occurred and high resistance grounding fault.The correctness,effectiveness and adaptability of the proposed method were verified by simulation results of distribuion network under different fault conditions.

A ONE TERMINAL TRANSIENT ENERGY BASED FAULTY PHASE SELECTION METHOD FOR PROTECTION OF DOUBLE CIRCUIT LINES

Fault Phase Selection for Series Compensated Extra High Voltage Transmission Lines Based on Transient Energy

A New Scheme of Faulty phase selection by voltage sequence component

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

Study of transient-based phase selection for EHV transmission line relaying

Transient-Based Faulty Phase Selection in EHV Transmission Lines

An Improved Fault Phase Selector for Transmission Line Protective Relay

A Phase Selector Based On Mathematical Morphology For Double Circuit Transmission Lines

Utility Fault Phase Selector Scheme for High Voltage Transmission Line Protection

Single-Phase Permanent Fault Detection for Reactored EHV/UHV Transmission Lines

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Fault Phase Selector on the Weak Feed Backside of Transmission Line Using Voltage Symmetrical Components

A fault phase selector for transmission line protective relaying using current fault components

NEW FAULT PHASE SELECTOR FOR DOUBLE-CIRCUIT LINES PROTECTIVE RELAYING BASED ON DIFFERENTIAL FAULT CURRENT COMPONENTS

Fault Phase Selection Method Applied to Tie Line of Renewable Energy Power Stations

Two-Dimensional Fault Line Detection Based on Transient Signal Features of Fault Phase

A practical fault phase selection scheme for untransposed double-circuit transmission lines on the same tower

Fault Phase Selector of Protective Relay for Cross Country Fault on Double Circuit Lines

A novel phase selection method based on instantaneous reactive power

Fault Classification and Faulted-Phase Selection Based on the Initial Current Traveling Wave

A Novel Fault Phase Selector for Double-Circuit Transmission Lines