Abstract:PurposeThe purpose of this paper is to study an electrolytic etching method to prepare fine lines on printed circuit board (PCB). And the influence of organics on the side corrosion protection of PCB fine lines during electrolytic etching is studied in detail. Design/methodology/approachIn this paper, the etching factor of PCB fine lines produced by new method and the traditional method was analyzed by the metallographic microscope. In addition, field emission scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS) were used to study the inhibition of undercut of the four organometallic corrosion inhibitors with 2,5-dimercapto-1,3,4-thiadiazole, benzotriazole, l-phenylalanine and l-tryptophan in the electrolytic etching process. FindingsThe SEM results show that corrosion inhibitors can greatly inhibit undercut of PCB fine lines during electrolytic etching process. XPS results indicate that N and S atoms on corrosion inhibitors can form covalent bonds with copper during electrolytic etching process, which can be adsorbed on sidewall of PCB fine lines to form a dense protective film, thereby inhibiting undercut of PCB fine lines. Quantum chemical calculations show that four corrosion inhibitor molecules tend to be parallel to copper surface and adsorb on copper surface in an optimal form. COMSOL Multiphysics simulation revealed that there is a significant difference in the amount of corrosion inhibitor adsorbed on sidewall of the fine line and the etching area. Originality/valueAs a clean production technology, electrolytic etching method has a good development indicator for the production of high-quality fine lines in PCB industry in the future. And it is of great significance in saving resources and reducing environmental pollution.

Application of modified simplex method to optimization of preparation of fine lines on printed circuit board by electrolytic etching

Study on fine lines and undercut suppression of printed circuit board prepared by electrolytic etching

A Novel Nitric Acid Etchant and Its Application in Manufacturing Fine Lines for PCBs

Manufacturing of Fine Lines by Semi-additive Process with Electroplating

Study on Wet Chemical Etching of Flexible Printed Circuit Board with 16-μm Line Pitch

Investigation on Chemical Etching Process of FPCB With 18 μ m Line Pitch

Research and optimization of through holes and fine lines with simultaneous electroplating

Study on Process Technique of Pcbs with Ladder Conductive Lines

Applied of Optimizing Tests in Technology Researched of the Electroless Copper of Sodium Hypophosphite

Orthogonal optimization the technique parameters made by the 50μm/50μm fine line

A study of post-etch wet clean on electrical and reliability performance of Cu/low k interconnections

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

Application of Uniform Design in the Technology Parameter Optimization of Desmear Process

Optimize RTR(Roll to Roll)Producing Parameters for 25μm/25μm COF Fine Lines

Novel, Simple, and Green Citrate-Based Copper Electronic Electroplating Bath in Microvia Void-Free Filling for Printed Circuit Board Application

Optimization of Metal-Assisted Etchant Components for Fabrication of Porous Silicon

Preparation of Electronic-Grade CuO for Copper Electrodeposition of Printed Circuit Boards

Optimizing The Electroplating Condition Of An Acid Low Cyanide Silver Bath And Its Application In Micromachining

Optimization Of Thin Metal Layer Etch Process For Hems/Sensor Application

Parameters optimization of high stability bath for electroless copper plating