Abstract:The 3D tri-gate FinFET device architecture is a key transistor scaling to 22nm node and beyond for its excellent short-channel performance[1]. However, compared with planar transistors, it poses greater challenge in the finFET gate etch.[2] As shown in fig.1, the etch needs to stop on top of the fin while etching further down to the STI oxide layer. Therefore, the top of fin needs to endure long time over etch without any structural damage which would adversely affect device performance. What’s more, the gate profile must be vertical and there should not be residual in the corner of gate and fin. It is not an easy task to achieve, at the same time, the three goals of vertical gate profile, no residual in the corner of fin and gate, as well as no structure damage on the top of fin, due to an unavoidable tradeoff. More specifically, vertical gate profile and no residual in the corner of fin demand strong etch function and light polymer, while no structure damage in the top of fin requires weak etch function and heavy polymer, which points to high etch selectivity of silicon to oxide layer. To achieve good etch results, one often falls into this dilemma. As far as we know, few publicly available papers have provided satisfactory solutions to the above- mentioned problem. In this work, we deal with it. The process of gate stack with CD below 30nm is illustrated in fig.2. Then, a HBr/O2 process in transformer coupled plasma is applied to finFET gate etch. As shown in fig.3, gate profile is vertical, fin is well protected and no residual appears in the corner fin. In conclusion, an HBr/O2 plasma etch process of finFET gate with CD below 30nm is investigated.Through appropriate tradeoff , an etch result of vertical gate profile, no residual in the sidewall and corner of fin, no structure damage on the top of fin is achieved.

Study on Wet Chemical Etching of Flexible Printed Circuit Board with 16-μm Line Pitch

Investigation on Chemical Etching Process of FPCB With 18 μ m Line Pitch

Study on fine lines and undercut suppression of printed circuit board prepared by electrolytic etching

Application of modified simplex method to optimization of preparation of fine lines on printed circuit board by electrolytic etching

Etching Technology for Copper-Clad Laminates Based on Femtosecond Laser

Fabrication of Double-Sided FPC by Hydrolyzing-Doping-Plating Additive Process

Effect of dislocation and residual stress on etching performance of 12 μm thick rolled copper foil during pre-stretching

Study on Process Technique of Pcbs with Ladder Conductive Lines

Manufacturing of Fine Lines by Semi-additive Process with Electroplating

A study of post-etch wet clean on electrical and reliability performance of Cu/low k interconnections

Electroless Plating Cycle Process for High-Conductivity Flexible Printed Circuits

A Novel Nitric Acid Etchant and Its Application in Manufacturing Fine Lines for PCBs

Plasma Etching and Parameters Optimizing for Flexible PI Substrate to Produce Flying Lead

Fine Pitch Flexible Printed Circuit Board Patterning for Miniaturized Endoscopic MicroUltrasound Arrays

Optimized chemical mechanical polishing of Parylene C for high-density wiring in flexible electronics

Research on Forming Mechanism and Optimization Scheme of Acid-Etched Pinhole on High-Density Packaging Substrate

Achieving High-Precision, Low-Cost Microfluidic Chip Fabrication with Flexible PCB Technology

Materials of Flexible Printed Circuit Board for High-Frequency Applications

Finfet Gate Etch Towards 16nm Node CMOS Technology

High Speed Copper Plating Process for IC Substrate

Influence of Etchants on Etched Surfaces of High-Strength and High-Conductivity Cu Alloy of Different Processing States