Achieving High-Precision, Low-Cost Microfluidic Chip Fabrication with Flexible PCB Technology

Andres Vanhooydonck,Thalissa Caers,Marc Parrilla,Peter Delputte,Regan Watts

DOI: https://doi.org/10.3390/mi15040425

IF: 3.4

2024-03-23

Micromachines

Abstract:Soft lithography has long remained the state of the art to generate the necessary micropatterning for molded microfluidic (MF) chips. Previous attempts to use printed circuit boards (PCBs) as a cheap and accessible alternative to expensive lithographed molds for the production of PDMS MF chip prototypes have shown their limitations. A more in-depth exploration of using PCBs as a mold substrate and a novel methodology of using flexible PCBs to produce highly accurate MF chips is reported here for the first time. Cross sections highlight the improved accuracy of this method, and peel testing is performed to demonstrate suitable adhesion between the glass substrate and PDMS cast. Positive cell growth viability showcases this novel method as a high-accuracy, high-accessibility, low-cost prototyping method for microfluidic chips while still maintaining all favorable properties provided by the PDMS material.

chemistry, analytical,nanoscience & nanotechnology,instruments & instrumentation,physics, applied

What problem does this paper attempt to address?

The paper mainly discusses how to manufacture microfluidic chips in a low-cost and high-precision manner. Traditional manufacturing of microfluidic chips usually relies on soft lithography, which is expensive. The researchers proposed a new method that uses flexible printed circuit board (PCB) technology to replace expensive lithography molds and produce prototypes of polydimethylsiloxane (PDMS) microfluidic chips.

They first conducted in-depth research on using PCB as a mold substrate and proposed a new method for producing high-precision microfluidic chips using flexible PCBs. Through cross-sectional analysis, the improvement in accuracy of this method was confirmed, and the appropriate adhesion between PDMS and glass substrate was verified through peel-off tests. Experimental results showed that this novel method is suitable for cell growth, demonstrating its potential in terms of biocompatibility and rapid prototyping of microfluidic chips.

The paper mentions several different types of PCBs, including bare copper traces, copper traces with solder layers, copper traces with fully covered solder layers, gold-plated copper traces on flexible PCBs, and flexible PCBs with cover layers. By comparing these different types of PCBs, the researchers optimized the patterning of microfluidic channels to achieve direct bonding with glass substrates and better accuracy.

In addition, the paper also conducted cross-sectional cutting, peel-off tests, functional tests, optical and scanning electron microscopy analysis, surface modification, and cell growth vitality tests to evaluate the performance and biocompatibility of the materials. Finally, the researchers proposed a new low-cost, high-precision, and easy-to-operate method for manufacturing microfluidic chips, which is particularly suitable for biomedical applications and the development of point-of-care testing (POCT) devices.