Abstract:A highly integrated, high performance, and re-configurable device, which is designed for the Nitrogen-Vacancy center based quantum applications, is reported. The digital compartment of the device is fully implemented in a Field-Programmable-Gate- Array. The digital compartment is designed to manage the multi-function digital waveform generation and the Time-to-Digital-Convertors. The device provides two Arbitrary-Waveform-Generator channels which operate at a 1 Gsps sampling rate with a maximum bandwidth of 500 MHz. There are twelve pulse channels integrated in the device with a 50 ps time resolution in both duration and delay. The pulse channels operate with the 3.3 V Transistor-Transistor logic. The FPGA-based Timeto- Digital-Convertor provides a 23-ps time measurement precision. A data accumulation module, which can record the input count rate and the distributions of the time measurement, is also available. A Digital-to-Analog-Convertor board is implemented as the analog compartment, which converts the digital waveforms to analog signals with 500 MHz low-pass-filters. All the input and output channels of the device are equipped with 50 Sub-Miniature version A termination. The hardware design is modularized thus it can be easily upgraded with compatible components. The device is suitable to be applied in the quantum technologies based on the N-V centers, as well as in other quantum solid state systems, such as quantum dots, phosphorus doped in silicon and defect spins in silicon carbide.

A fast and compact timing discriminator

Pulsed Light Time-of-flight Measurement Based on a Differential Hysteresis Timing Discrimination Method.

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

A reconfigurable calibration-free digital-to-time converter based on a high-speed transceiver

Development of a NIM Module for Time-to-digital Conversion

A New Time-Digital Convert Circuit Based on Digital Delay Line

A high precision TDC based on a multi-phase clock

An integrated device with high performance multi-function generators and Time-to-digital convertors

A high precision, high linearity 10 bit Digital-to-Time Converter circuit.

A Novel Low Power Time-Mode Comparator for Successive Approximation Register Adc

A low-power coarse-fine time-to-digital converter in 65nm CMOS

A Current-sensitive Preamplifier/Discriminator Used for Small Fast Signals

A PVT-Aware and Low Power Pulse-Triggered Flip-Flop

A Mixed-Signal Timing Circuit in 90nm CMOS for Energy Detection IR-UWB Receivers

A Low-power Synthesizable Time-to-Digital Converter Using Amplification to Overcome Mismatch

NIM - TTL and TTL - NIM converters for single particle pulse counting experiments

Time-to-digital Converter for Frequency Synthesis in 0.18 Μm CMOS

NTIMP1—A Fast Pulse Readout Chip With 1.2 V Power Supply Applied to the Diamond Detector in HIAF

On-chip Picosecond Resolution Timing Measurement Using Time Amplifier

An Improved Digital Timing Recovery Circuit For Burst-Mode Communications

A Pico-second Resolution Sensor of NTV DFF Timing Variation with Cancelling Errors from PVT and RC Delay along Testing Path