Abstract:This article presents a resolution-tunable time-to-digital converter (TDC) with a three-level structure, in which the low-level TDC employs an improved all-digital delay-locked loop (ADDLL) based on a cyclic pulse ring oscillator (CPRO) and a digital controller for detection lock state (DLS). Specifically, a bidirectional bypass transmission delay unit (BBTDU) in CPRO provides adjustable resolution with a 15 ps coarse delay step and a 3.5 ps fine delay step. Second, a data processing approach is presented to open the window to extract a 4-bit binary data of the bidirectional serial shift register line (BSSRL) in ADDLL for DLS and update the values of BSSRL at the same position of windowing, which can reduce the number of manipulated registers in BSSRL by approximately 93.7%. Then, a methodology of detecting the locking pattern between lock and unlock and selecting the fixed optimal windowing sequence to update the controlling values of BSSRL is proposed to eliminate dithering in a locked state, which can reduce the clock phase jitter when locked. Finally, the proposed TDC has been integrated into a system-on-chip (SoC) and fabricated in 65-nm CMOS technology. The measurement results implemented with a 30 MHz reference clock demonstrate that a resolution-tunable TDC with low power has been obtained. There are six configurable resolutions in all. When configured to a minimum resolution of 7.78 ps, the power consumption and the precision are 4.812 mW and 3.02 ps, respectively. While configured for a maximum resolution of 29.7 ps, the power consumption and the precision are 2.874 mW and 13.2 ps, respectively. The proposed TDC is extremely flexible and well-suited for integration into other large-scale application-specific integrated circuit (ASIC) chips to extend the application range, especially for low-frequency applications.

Time-to-digital Converter for Frequency Synthesis in 0.18 Μm CMOS

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A 108fsrms 0.45mW 100MS/s 1.25MHz bandwidth multi-bit ΔΣ time-to-digital converter with dynamic element matching

A low-power coarse-fine time-to-digital converter in 65nm CMOS

A Low Power Tdc With 0.5ps Resolution For Adpll In 40nm Cmos

A Vernier Time-to-Digital Converter with 1.5ps Resolution for an All-Digital Phase Locked Loop in 28nm CMOS.

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

A 108fs(Rms) 0.45mw 100ms/S 1.25mhz Bandwidth Multi-Bit Delta Sigma Time-To-Digital Converter With Dynamic Element Matching

A Low-power Synthesizable Time-to-Digital Converter Using Amplification to Overcome Mismatch

A High-Resolution Time-To-Digital Converter Based on Parallel Delay Elements

A 10b, 0.7ps resolution coarse-fine time-to-digital converter in 65nm CMOS using a time residue amplifier

A 1ps Resolution Two-Step Time-to-digital Converter Using Parallel Digital-to-time Converters

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array

A high precision TDC based on a multi-phase clock

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

A High-Resolution, High-Linearity, Two-Step Time-to-Digital Converter for Wideband Counter-Assisted ADPLL in 0.13um CMOS

A High-Throughput Vernier Time-to-Digital Converter on FPGAs with Improved Resolution Using a Bi-Time Interpolation Scheme

A 0.8ps minimum-resolution sub-exponent TDC for ADPLL in 0.13µm CMOS

High-Resolution Time-to-Digital Converters Implemented on 40-, 28-, and 20-Nm FPGAs

A 1.3mW 8-bit Two-step Time-to-Digital Converter

A Resolution-Tunable Low Power Time-to-Digital Converter With an Improved ADDLL Based on a Cyclic Pulse Ring Oscillator