Abstract:Wide frequency coverage phase locked loops (PLL) with fine frequency resolution and low phase noise are one of the most critical building blocks for the high speed communication systems. Voltage domain quantization scheme employing ADCs has been proposed in previous fractional-N PLLs as an alternative to DTC-based quantization cancellation. However, though the voltage-domain quantization is linear in modern processes, the potential nonlinearity in the time-to-voltage conversion preceding the ADC results in fractional spurs and noise folding, which will severely degrade the PLL output if not properly addressed. One approach applies linearity compensation that often requires sophisticated digital processing [1]–[2]. The other approach utilizes digital-to-time converters (DTC) or digital-to-analog converters (DAC) to generate a replica of the divider quantization noise and then cancels out this noise in the analog domain before it propagates into the loop [3]–[4], thus relaxing the requirement for linear phase detection range. Prior arts have achieved remarkable phase noise performances, at the cost of significantly higher design complexity. This work describes a wideband fractional-N PLL that uses an integrator-based time-to-voltage converter and a 10-bit SAR ADC for direct phase error digitization as shown in Fig. 1. Without linearity calibration or DTC/DAC-based quantization noise cancellation, the proposed PLL achieves low fractional spur and low jitter across a wide frequency range.

A High-Resolution, High-Linearity, Two-Step Time-to-Digital Converter for Wideband Counter-Assisted ADPLL in 0.13um CMOS

A Wide Range and High Resolution Two-Step TDC for Millimeter-Wave Band ADPLL

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A 2.5ghz Adpll With Pvt-Insensitive Delta Sigma Dithered Time-To-Digital Conversion By Utilizing An Addll

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

An Asynchronous Delay Line TDC for ADPLL in 0.13um CMOS.

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

A 0.8ps minimum-resolution sub-exponent TDC for ADPLL in 0.13µm CMOS

An 11-Bit and 39 Ps Resolution Time-To-Digital Converter for Adpll in Digital Television

A 360μw Vernier Time-to-Digital Converter for ADPLL in IoT Applications

A Low-Noise, 8.95&#x2013;11ghz All-Digital Frequency Synthesizer with a Metastability-Free Time-to-digital Converter and a Sleepy Counter in 65nm CMOS

A Low Power Tdc With 0.5ps Resolution For Adpll In 40nm Cmos

A 5.4 GHZ All-Digital Phase-Locked Loop with a wide output swing and high-linearity DAC

A 1.3mW 8-bit Two-step Time-to-Digital Converter

A 1.9 GHz ADPLL with 130 Reference Cycles Settling Time in 0.18 Μm CMOS Technology

A Sub-ps Integrated-Jitter 10 GHz ADPLL with Fractional Capacitor

A Vernier Time-to-Digital Converter with 1.5ps Resolution for an All-Digital Phase Locked Loop in 28nm CMOS.

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC