Abstract:This article presents a resolution-tunable time-to-digital converter (TDC) with a three-level structure, in which the low-level TDC employs an improved all-digital delay-locked loop (ADDLL) based on a cyclic pulse ring oscillator (CPRO) and a digital controller for detection lock state (DLS). Specifically, a bidirectional bypass transmission delay unit (BBTDU) in CPRO provides adjustable resolution with a 15 ps coarse delay step and a 3.5 ps fine delay step. Second, a data processing approach is presented to open the window to extract a 4-bit binary data of the bidirectional serial shift register line (BSSRL) in ADDLL for DLS and update the values of BSSRL at the same position of windowing, which can reduce the number of manipulated registers in BSSRL by approximately 93.7%. Then, a methodology of detecting the locking pattern between lock and unlock and selecting the fixed optimal windowing sequence to update the controlling values of BSSRL is proposed to eliminate dithering in a locked state, which can reduce the clock phase jitter when locked. Finally, the proposed TDC has been integrated into a system-on-chip (SoC) and fabricated in 65-nm CMOS technology. The measurement results implemented with a 30 MHz reference clock demonstrate that a resolution-tunable TDC with low power has been obtained. There are six configurable resolutions in all. When configured to a minimum resolution of 7.78 ps, the power consumption and the precision are 4.812 mW and 3.02 ps, respectively. While configured for a maximum resolution of 29.7 ps, the power consumption and the precision are 2.874 mW and 13.2 ps, respectively. The proposed TDC is extremely flexible and well-suited for integration into other large-scale application-specific integrated circuit (ASIC) chips to extend the application range, especially for low-frequency applications.

A 0.8ps minimum-resolution sub-exponent TDC for ADPLL in 0.13µm CMOS

A Low Power Tdc With 0.5ps Resolution For Adpll In 40nm Cmos

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A Wide Range and High Resolution Two-Step TDC for Millimeter-Wave Band ADPLL

A 10b, 0.7ps resolution coarse-fine time-to-digital converter in 65nm CMOS using a time residue amplifier

A High-Resolution, High-Linearity, Two-Step Time-to-Digital Converter for Wideband Counter-Assisted ADPLL in 0.13um CMOS

An Asynchronous Delay Line TDC for ADPLL in 0.13um CMOS.

A 1.3mW 8-bit Two-step Time-to-Digital Converter

A 360μw Vernier Time-to-Digital Converter for ADPLL in IoT Applications

An 11-Bit and 39 Ps Resolution Time-To-Digital Converter for Adpll in Digital Television

A 108fsrms 0.45mW 100MS/s 1.25MHz bandwidth multi-bit ΔΣ time-to-digital converter with dynamic element matching

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

A 2.5ghz Adpll With Pvt-Insensitive Delta Sigma Dithered Time-To-Digital Conversion By Utilizing An Addll

A 108fs(Rms) 0.45mw 100ms/S 1.25mhz Bandwidth Multi-Bit Delta Sigma Time-To-Digital Converter With Dynamic Element Matching

A 108fs<sub>rms</sub> 0.45mW 100MS/s 1.25MHz bandwidth multi-bit ΔΣ time-to-digital converter with dynamic element matching

A low-power coarse-fine time-to-digital converter in 65nm CMOS

All‐digital PLL with ΔΣ DLL Embedded TDC

A Resolution-Tunable Low Power Time-to-Digital Converter With an Improved ADDLL Based on a Cyclic Pulse Ring Oscillator

A Fractional- N DTC-based ADPLL using path-select multi-delay line TDC and true fractional division technique

A Low-power Synthesizable Time-to-Digital Converter Using Amplification to Overcome Mismatch