Abstract:Time-to-digital converters (TDCs) act as a core component in many timing-critical systems. Tapped delay line is the most widely used style for the field-programmable gate-array (FPGA)-based TDCs, but it suffers from several intractable problems such as poor nonlinearity and long delay-line occupation. Recently, a new ring-oscillator-based Vernier TDC circuit using carry chains was demonstrated to have much smaller nonlinearity with a much shorter delay line. Since the used delay line is not compensated, the timing jitter increases (or the precision degrades) remarkably when the oscillation number is large. This would incur undesirable lower resolution selection to maintain acceptable precision. In this article, a novel bidirectional-operating Vernier delay line structure is proposed to reduce the required oscillation number during the fine time measurement. Traditionally, for the Vernier delay line, the fast signal propagates along the slow delay line, while the slow signal propagates along the fast delay line, to which we call the normal Vernier delay line. The new structure proposes two parallelized Vernier delay line, consisting of one normal Vernier delay line and another abnormal Vernier delay line. The term "abnormal" refers to that the fast and slow signals are unusually fed to the fast and slow delay lines, respectively. A prototype TDC circuit based on this new method was implemented on a Stratix III FPGA. Test results demonstrate that by adopting the proposed novel circuit architecture, both the resolution and the root-mean-square error can be improved from the 30–40-ps level to the 20–30-ps level.

A New Time-Digital Convert Circuit Based on Digital Delay Line

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

A high precision, high linearity 10 bit Digital-to-Time Converter circuit.

A High Resolution Large Dynamic Range TDC Circuit Implementation

A low-power coarse-fine time-to-digital converter in 65nm CMOS

A Vernier Time-to-Digital Converter with 1.5ps Resolution for an All-Digital Phase Locked Loop in 28nm CMOS.

A High-Precision Coarse-Fine Time-to-digital Converter with the Analog-Digital Hybrid Interpolation

Two-Stage Clock-Free Time-to-Digital Converter Based on Vernier and Tapped Delay Lines in FPGA Device

A High-Resolution Time-To-Digital Converter Based on Parallel Delay Elements

Design of a High Speed Low Power Time-to-Digital Converter Based on Multi-stage Amplification Structure

A High-Linearity Vernier Time-to-Digital Converter on FPGAs With Improved Resolution Using Bidirectional-Operating Vernier Delay Lines

A High Resolution Time-to-Digital Converter (TDC) Based on Self-Calibrated Digital-to-Time Converter (DTC).

An Fpga-Integrated Time-To-Digital Converter Based on A Ring Oscillator for Programmable Delay Line Resolution Measurement

Design and Test of a Time-to-Digital Converter ASIC Based on a Differential Delay Line

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

A Three-Step Multi-Resolution Time-to-Digital Converter.

Design of A Delay-Locked-Loop-Based Time-To-Digital Converter

A Time-to-digital-converter Utilizing Bits-Counters to Decode Carry-Chains and DSP48E1 Slices in a Field-Programmable-gate-array

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array

Research of Precise Timing System Based on Frequency-time Conversion