Abstract:Prediction of two-phase boiling flows using the computational fluid dynamics (CFD) approach is very challenging since several sub-models for interfacial mass, momentum and energy transfer in such flows are still not well established and require further development and validation. Once validating a particular model, it is important that all key parameter involved in the model are carefully verified. Such verification is typically performed by separate effect tests, where one parameter at a time is compared to a measured or otherwise known value. Needless to say that for complex models, which are typical for CFD applications to two-phase flow, the number of independent parameters that need to be verified can be quite high. This particular feature makes the validation process of complex CFD models in open source codes very attractive, since full access to the implementation details is possible. This paper is concerned with implementation and validation of two-phase boiling bubbly flow models using the OpenFOAM, open source environment. The model employs the two-fluid formulation of the conservation equations with the Reynolds-averaged treatment of the turbulent terms. The model consists of six conservation equations for the liquid and the vapor phase, allowing for the thermodynamic non-equilibrium and compressibility of both phases. In addition, the model includes two transport equations for the turbulence kinetic energy and energy dissipation and one transport equation for the interfacial area concentration. New models for wall heat partitioning as well as for the phase change terms in nucleate boiling have been implemented. Sensitivity studies as well as validation of the model against measured data available in the open literature have been performed and it has been shown that a reasonable agreement between predictions and experiments has been achieved.

Effect of Turbulence Model on Prediction of Subcooled Boiling

Effects of Turbulence Models on Forced Convection Subcooled Boiling in Vertical Pipe

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Uncertainty Analysis on K-Ε Turbulence Model in the Prediction of Subcooled Boiling in Vertical Pipes

Effects of Interaction Models on Upward Subcooled Boiling Flow in Annulus

PREDICTION OF SUBCOOLED BOILING WITH UNCERTAINTIES FROM BOUNDARY CONDITIONS AND INTERACTION MODELS

Investigation on the Effects of Model Uncertainties on Subcooled Boiling

Investigation on the Subcooled Boiling in Vertical Pipe with Uncertainties from Boundary Conditions by Using FLUENT

Evaluation of several liquid–vapor phase change models for numerical simulation of subcooled flow boiling

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Numerical Prediction of Transitional Features of Turbulent Forced Gas Flows in Circular Tubes with Strong Heating

Performance assessment of turbulence models in CFX for predicting heat transfer of supercritical water

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Assessment Of Performance Of Turbulence Models Of Cfx In Predicting Supercritical Water Heat Transfer In A Vertical Tube

Numerical Simulation of Subcooled Boiling Water in Vertical Concentric Annulus under Low Pressure

A BUBBLE-LAYER-BASED MECHANISTIC MODEL FOR THE SLIGHTLY SUBCOOLED FLOW BOILING IN VERTICAL TUBES

Influence of non-uniform wall heat flux on critical heat flux prediction in upward flowing round pipe two-phase flow

Effect of Forced Convection Heat Transfer on Vapor Quality in Subcooled Flow Boiling

Implementation and validation of two-phase boiling flow models in OpenFOAM

Assessment of Nucleation Boiling Models and Improvement by the Chen Correlation for Two-fluid Model CFD

A Mechanistic Model for Slightly Subcooled Flow Boiling in Vertical Tubes