Abstract:Prediction of two-phase boiling flows using the computational fluid dynamics (CFD) approach is very challenging since several sub-models for interfacial mass, momentum and energy transfer in such flows are still not well established and require further development and validation. Once validating a particular model, it is important that all key parameter involved in the model are carefully verified. Such verification is typically performed by separate effect tests, where one parameter at a time is compared to a measured or otherwise known value. Needless to say that for complex models, which are typical for CFD applications to two-phase flow, the number of independent parameters that need to be verified can be quite high. This particular feature makes the validation process of complex CFD models in open source codes very attractive, since full access to the implementation details is possible. This paper is concerned with implementation and validation of two-phase boiling bubbly flow models using the OpenFOAM, open source environment. The model employs the two-fluid formulation of the conservation equations with the Reynolds-averaged treatment of the turbulent terms. The model consists of six conservation equations for the liquid and the vapor phase, allowing for the thermodynamic non-equilibrium and compressibility of both phases. In addition, the model includes two transport equations for the turbulence kinetic energy and energy dissipation and one transport equation for the interfacial area concentration. New models for wall heat partitioning as well as for the phase change terms in nucleate boiling have been implemented. Sensitivity studies as well as validation of the model against measured data available in the open literature have been performed and it has been shown that a reasonable agreement between predictions and experiments has been achieved.

Investigation on the Effects of Model Uncertainties on Subcooled Boiling

CFD Simulations and Experimental Verification on Nucleate Pool Boiling of Liquid Nitrogen

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Investigation on the Subcooled Boiling in Vertical Pipe with Uncertainties from Boundary Conditions by Using FLUENT

PREDICTION OF SUBCOOLED BOILING WITH UNCERTAINTIES FROM BOUNDARY CONDITIONS AND INTERACTION MODELS

Uncertainty Analysis on K-Ε Turbulence Model in the Prediction of Subcooled Boiling in Vertical Pipes

Effects of Turbulence Models on Forced Convection Subcooled Boiling in Vertical Pipe

Numerical Simulation of Subcooled Boiling Water in Vertical Concentric Annulus under Low Pressure

Effect of Turbulence Model on Prediction of Subcooled Boiling

CFD Investigation of Subcooled Flow Boiling Model under Low Pressure

Effects of Interaction Models on Upward Subcooled Boiling Flow in Annulus

Validation and Uncertainty Quantification for Wall Boiling Closure Relations in Multiphase-CFD Solver

Evaluation of several liquid–vapor phase change models for numerical simulation of subcooled flow boiling

Numerical Study on Bubble Departing Behavior from Heated Surface in Subcooled Pool Boiling

Numerical Study on Bubble Behaviour and Heat Transfer Characteristics of Subcooled Pool Boiling Based on Non-Empirical Boiling and Condensation Model

A Mechanistic Model for Slightly Subcooled Flow Boiling in Vertical Tubes

UNCERTAINTY ANALYSIS FOR NUMERICAL MODELING OF SURFACE HEAT TRANSFER CHARACTERISTICS IN EXPERIMENTS—APPLICATION TO POST-CHF FLOW BOILING TESTS

A BUBBLE-LAYER-BASED MECHANISTIC MODEL FOR THE SLIGHTLY SUBCOOLED FLOW BOILING IN VERTICAL TUBES

Implementation and validation of two-phase boiling flow models in OpenFOAM

Experimental Investigation and Model Prediction of Sliding Bubble Dynamics in Vertical Subcooled Boiling Flow

Modeling of Low-Pressure Subcooled Boiling Flow of Water Via the Homogeneous MUSIG Approach