Abstract:In the selective laser melting process, metal powder melted by the laser heat source generates large instantaneous energy, resulting in transient high temperature and complex stress distribution. Different temperature gradients and anisotropy finally determine the microstructure after melting and affect the build quality and mechanical properties as a result. It is important to monitor and investigate the temperature and stress distribution evolution. Due to the difficulties in online monitoring, finite element methods (FEM) are used to simulate and predict the building process in real time. In this paper, a thermo-mechanical coupled FEM model is developed to predict the thermal behaviors of the melt pool by using Gaussian moving heat source. The model could simulate the shapes of the melt pool, distributions of temperature and stress under different process parameters through FEM. The influences of scanning speed, laser power, and spot diameter on the distribution of the melt pool temperature and stress are investigated in the SLM process of Al6063, which is widely applied in aerospace, transportation, construction and other fields due to its good corrosion resistance, sufficient strength and excellent process performance. Based on transient analysis, the relationships are identified among these process parameters and the melt pool morphology, distribution of temperature and thermal stress. It is shown that the maximum temperature at the center point of the scanning tracks will gradually increase with the increment of laser power under the effect of thermal accumulation and heat conduction, as the preceded scanning will preheat the subsequent scanning tracks. It is recommended that the parameters with optimized laser power (P = 175–200 W), scanning speed (v = 200–300 mm/s) and spot diameter (D = 0.1–0.15 mm) of aluminum alloy powder can produce a high building quality of the SLM parts under the pre-set conditions.

Numerical Simulation of Thermal Distribution in Direct Metal Laser Sintering

Finite Element Simulation of Temperature Field in Si/Fe Powder Mixtures During Selective Laser Sintering

Thermo-Fluid-Dynamic Modeling of the Melt Pool During Selective Laser Melting for AZ91D Magnesium Alloy

Numerical Simulation and Parametric Analysis of Selective Laser Melting Process of AlSi10Mg Powder

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Effect of Processing Parameters on Thermal Phenomena in Direct Laser Metallic Powder Deposition

Three-dimensional non-isothermal phase-field modeling of microstructure evolution during selective laser sintering

Advances in Thermal Modeling of Selective Laser Sintering of Metal Powders

Modeling of Temperature Field Evolution During Multilayered Direct Laser Metal Deposition

Three-Dimensional Transient Simulation of Laser Deep-penetration Welding Based on Combined Heat Source

The Thermo-Mechanical Coupling Effect in Selective Laser Melting of Aluminum Alloy Powder

Analytical and numerical analysis of heat transfer and temperature distribution in laser sintering method

Numerical Simulation of Temperature Field in Multilayer Heterogeneity Lamination Laser Soldering

Numerical simulation of the thermal behaviors for two typical damping alloys during selective laser melting

3D Numerical Simulation of Temperature Field Coupled with Flow Field of the Liquid Metal in Shot Sleeve of Die Casting Process

Improving the accuracy and reliability of temperature field simulation during laser metal deposition

Modeling and numerical studies of selective laser melting: Multiphase flow, solidification and heat transfer

Simulation of temperature field and stress field of selective laser melting of multi-layer metal powder

Study on Thermodynamic Behavior, Microstructure and Mechanical Properties of Thin-Walled Parts by Selective Laser Melting

Thermal Analysis and Verification for Direct Metal Deposition of 0Cr18Ni9 Stainless Steel

Heat transfer model and finite element formulation for simulation of selective laser melting