Abstract:Despite numerous studies focused on the hydrothermal (HT) synthesis of fly ash zeolites (FAZs), this method still has many limitations, the main of which is the low yield of zeolites. Hydrothermally synthesized zeolites are typically multiphase and exhibit low purity, which limits their applicability. Pure-phase zeolites have been primarily prepared from filtrates after alkaline mineralization of fly ashes, not directly in suspension. In addition, the published methodologies have not been tested in a wider set of samples, and thus their reproducibility is not confirmed. The aim of the study is to propose a reproducible methodology that overcomes the mentioned limitations. The influence of the Si/Al ratio (1.3:1–1:2), the type and concentration of the activator (2/4 M NaOH/KOH/LiOH), the reagent (30% LiCl), the duration (24–168 h), and the temperature (50–180 °C) of the synthesis phases were studied. The sequence of the synthesis phases was also optimized, depending on the type of heat transfer. The fly ashes were analyzed by wavelength-dispersive X-ray fluorescence (WD XRF), flame atomic absorption spectrometry (F-AAS), and X-ray diffraction (XRD). The energy intensity of the synthesis was reduced through the application of unique microwave digestion technology. Both microwave and combined (microwave and convection) syntheses were conducted. FAZs were identified and quantified by XRD analysis. This study presents a three-stage (TS) hydrothermal synthesis of pure-phase sodalite in suspension. Sodalite (>99 wt.%) was prepared from nine fly ashes under the following conditions: I. microwave phase: 120 °C, 150 min, solid-to-liquid ratio (S/L) 1:5, Si/Al ratio 1:1.5, and 4 M NaOH; II. convection phase: 120 °C, 24 h, S/L 1:40, and the addition of 30 mL of 30% LiCl; and III. crystallization: 70 °C for 24 h. The formation of rhombododecahedral sodalite crystals was confirmed by scanning electron microscope (SEM) images.

Hydrothermal Synthesis of Wollastonite from Alkaline Sodium Silicate Solution

Preparation of Acicular Wollastonite Using Hydrothermal and Calcining Methods

Hydrothermal Synthesis of Wollastonite from Desilication Filtrate

An Experimental Study on Preparation of Nanocrystalline Wollastonite Powders from Sodium-Calcium Siliceous Hydration Residue

Hydrothermal Synthesis of Acicular Wollastonite from Potassium Silicate Solution

Preparation of Nano-Sized Wollastonite Using Calcium Silicate Residue of Potassium Feldspar after Extraction of Potassium and Alumina

Synthesis of Pure-Silica Mtw Powder and Supported Films

Coprecipitation of Crystalline Calcium Silicates and Carbonates from the Hydrothermal Reaction of Pseudowollastonite

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Synthesis and Characterization of Analcime Using Quartz Syenite Powder by Alkali-Hydrothermal Treatment

Hydrothermal Crystallization of Nano-kaolinite from Precursor of Acid Treating Kalsilite

Control of crystallization rate and morphology of zeolite silicalite-1 in solvent-free synthesis

Preparation of Wollastonite Glass-ceramics by Using Silicate-calcium Slag Generated in Process of Extracting Alumina from High-alumina Fly Ash

Simple and rapid synthesis of zeolite W from K‐feldspar via the improved hydrothermal method

Development of porous silica production by hydrothermal method

Microwave-Assisted Hydrothermal Synthesis of Pure-Phase Sodalite (>99 wt.%) in Suspension: Methodology Design and Verification

Alkali Activation of Metakaolin and Wollastonite: Reducing Sodium Hydroxide Use and Enhancing Gel Formation through Carbonation

Crystal Evolution of Calcium Silicate Minerals Synthesized by Calcium Silicon Slag and Silica Fume with Increase of Hydrothermal Synthesis Temperature

Synthesis of White Mineral Trioxide Aggregate (WMTA) Using Silica from Rice Husk Ash and CaCO3 from Limestone

Synthesis of Kalsilite from Microcline Powder by an Alkali-Hydrothermal Process

Utilization of industrial waste materials for the preparation of wollastonite by temperature-induced forming technique