Preparation of Polypropylene/MMT Nanocomposites Using Complex Supported Catalysts

张延武,范宏,李伯耿

DOI: https://doi.org/10.3321/j.issn:1003-9015.2005.01.023

2005-01-01

Abstract:A new type of heterogeneous Z-N catalyst was prepared by using mixture of Mg-Montmorillonite (MMT) and Mg(OEt)2 as complex support. Using the complex supported catalysts the polypropylene(PP)/MMT nanocomposites were produced via in-situ polymerization. The complex supported catalysts have much higher catalytic activity and give higher PP molecular weight than catalysts using MMT as support alone. The catalytic activity was increased and the Al/Cat ratio needed for polymerizing could be reduced when retreatment of TiCl4 was applied during the support procedure. It is found that under lower Al/Cat ratio, the activity of the complex supported catalyst Cat 5 prepared from Mg-MMT/Mg(OEt)2/TiCl4/ EB can be improved by adding a few amount of styrene during polymerization. Among all the complex supported catalysts studied, the Cat 6 prepared from Mg-MMT/Mg(OEt)2/ Ti(OBa)4/ TiCl4/ EB has the best performance of high activity and low Al/Cat needed, and it is believed to be the suitable catalyst for the preparation of PP/MMT nanocomposites. Results from WAXS analysis and TEM observation of the composites indicate that MMT layers have exfoliated and dispersed in PP matrix during polymerization. The melt temperature (Tm) of the products is similar to commodity PP.