Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Experimental research of the flow field by using PDA in a new cyclone-type separator

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW IN A SQUARE CYCLONE SEPARATOR WITH DOWNWARD GAS EXIT BY 3D-PDA

Experimental study on a new type of cyclone separator for fine particles

EXperimetal Study on the Diffusion Square Cyclone Seoarator

Experimental investigation on separation characteristics of axial cyclone separator

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

FLOWPATTERN EFFECT ON THE SEPARATION PERFORMANCE IN CENTRIFUGAL SEPARAT OR

Numerical Simulation And Piv Study Of The Turbulent Flow In A Cyclonic Separator

Numerical Simulation of the Flow Field and Performance of an Innovative Cyclone Separator with a Downward Discharge of Gases

Experimental study of two-phase flow inside finned-tubes separator using 3-D-PDA

CFD Investigation on the Performance of Cyclone Separators with Divergent or Convergent Insertion Pipes

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

Study of the performance and flow field of a new spiral-roof cyclone separator

Experimental Study on the Particle Distribution in a Square Cyclone Separator

Study on velocity field in hydrocyclone model by PDPA measurement

ICONE19-43328 PERFORMANCE ANALYSIS OF CYCLONE SEPARATOR AND ITS OPTIMIZATION

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Effect of Internally Mounted Helical Fins on the Separation Performance of a Cylindrical Gas-Solid Cyclone Separator

Numerical Simulation of Three-Dimension Flow Field in a New-Type Cyclone Separator with a Radial Inlet Structure

Experimental Research on Separation Performance for Square Cyclone Separator under Different Constructional Details