Abstract:Dimethyl carbonate (DMC) is a promising green chemical that plays a significant role in the sustainable chemical industry, clean energy technologies, and environmental protection. In response to the challenges of high equipment investment and energy consumption in the existing process for producing dimethyl carbonate through an ester exchange reaction using vinyl carbonate and methanol, a new reactive dividing-wall column (RDWC) process was developed. A new RDWC model was established by using Aspen Plus. The impact factors of reaction conditions such as reactant molar ratio, theoretical number of reaction stages, reaction pressure, and separation conditions such as theoretical number of common rectifying section, theoretical number of common stripping section, liquid phase distribution on both sides of the dividing wall, and side draw location were analyzed. A laboratory-scale new RDWC was designed and built referenced to the simulation results. The experimental research investigated key parameters affecting the reaction distillation column, such as the reaction zone height, reactant molar ratio, liquid phase distribution, reflux ratio, and vapor phase distribution on both sides of the dividing wall. This research laid the foundation for the scale-up designing of process parameters for the new RDWC. Under optimized conditions, the conversion rate of reactant EC (ethylene carbonate) exceeded 99.9%, the purity of methanol in the side draw was at least 99 wt %, and the purity of methanol ethylene glycol in the distillation column achieved a concentration greater than 99% (excluding the catalyst). The new method can greatly shorten the transesterification process (integrate the three towers in the original process into one) to produce dimethyl carbonate, save investment, and reduce energy consumption.

Research Progress on Seperation Process for One-step Synthesis of Dimethyl Ether from Syngas

Technologies of Separating Alkene from Refinery Dry Gas

One-step Synthesis of Dimethyl Ether from Semi-water Gas for Industrial Trial Production

Research on a New 2-(2-Dimethylaminoethoxy) Ethanol Synthesizing Process

Progress on Reforming of Carbon Dioxide and Methane to Synthesis Gas by Thermal Plasma

Thermodynamics of the Single-Step Synthesis of Dimethyl Ether from Syngas

A near-zero carbon emission methanol production through CO2 hydrogenation integrated with renewable hydrogen: Process analysis, modification and evaluation

Energy-efficient separation alternatives: metal-organic frameworks and membranes for hydrocarbon separation.

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

Process optimization of CO2membrane and cryogenic hybrid separation

Techno-Economic Analysis of Methanol to Propylene Process

Progress in the One-Step Mass Production of Dimethyl Ether Using Circulating Slurry Reactors

Study on synthesis of dimethyl ether from syngas obtained by biomass gasification

Thermodynamic Optimization of Dimethyl Ether Synthesis from Syngas in Polygeneration Systems

Synthetic fuels and chemicals production from biomass synthesis gas

Separation enhanced methanol and dimethyl ether synthesis

Experimental study of improved two step synthesis for DME production

Synthesis of dimethyl ether from greenhouse gas CO_2

Process design and downstream optimization of the direct synthesis route for cleaner production of dimethyl ether from biogas

Recent Researches on Process from Methanol to Olefins

Study on a New Reactive Dividing-Wall Column for the Reaction of Vinyl Carbonate and Methanol Ester Exchange to Produce Dimethyl Carbonate