Abstract:The harmonic method using a symmetric double probe was developed for measuring electron temperature and ion density (Meas. Sci. Technol. 23 085001). When an alternating voltage is applied to the symmetric double probe where the two areas of the collector for current collection are equal, the fundamental frequency current and third harmonic currents are generated. The electron temperature and ion density are obtained by measuring the fundamental frequency current and the third harmonic current. However, it is observed that the third harmonic current can rapidly decrease to the level of base noise when the ratio of the applied voltage to the electron temperature decreases. Therefore, it is necessary to increase the harmonic currents generated to improve measurement accuracy for electron temperature and ion density. In this paper, a harmonic method using an asymmetric double probe with different collection areas is proposed to measure electron temperature and ion density. By using the double probe with different collector area, the fundamental frequency current and the second harmonic current are generated. In the proposed method, the electron temperature and ion density are obtained by measuring the fundamental frequency current and the second harmonic current. It is found that the accuracy of the electron temperature can be improved by measuring the second harmonic rather than measuring the third harmonic current. For quantitative comparison, the electron temperature and ion density obtained by the proposed method were compared with the electron temperature and electron density obtained by the measurement electron energy probability function, which showed good agreement between them in argon plasma at various conditions. In addition, it was experimentally verified that the electron temperature can be accurately measured even when the chamber is electrically insulated, and a dielectric layer is deposited on the collectors of the double probe, such as in the plasma process.

A Method to Correct the Characteristic Curve of a Langmuir Probe and the Possibility to Measure Plasma Electron Temperature Through Ion-Acoustic Waves

New Experimental Results Obtained using Microwave Reflectometry in HL-2 A Tokamak

Microwave Diagnostics System in the HL-2A Tokamak

Advances in Thermal Plasma Temperature Diagnostic Methods

The ac-coupling between a Langmuir probe and a plasma and its effect on the plasma density measurement in the afterglow

Measurement of plasma electron energy distribution functions by Langmuir probe using a modified AC modulation method

Comparative studies of cold/hot probe techniques for accurate plasma measurements

Study of plasma parameters in high enthalpy ICP-heated wind tunnel by using single Langmuir probe

A harmonic method for measuring electron temperature and ion density using an asymmetric double probe

Analysis of uncertainty in measurement of electron temperature in low-pressure inductively coupled plasmas using microwave cutoff probe

Experimental Evaluation of Langmuir Probe Sheath Potential Coefficient on the HL-2A Tokamak

Theoretical and Experimental Study of the Microwave Cut-off Probe for Electron Density Measurements in Low-Temperature Plasmas

Improved analysis techniques for cylindrical and spherical double probes

Langmuir analysis of electron beam induced plasma in environmental TEM

Characteristics of Langmuir Probe in Low Temperature, Weakly Magnetized Plasmas

Measurement of plasma electron temperature with an ion beam probe

Research on Low Pressure Electronic Density Diagnostic Method of Single Paperback Probe Based on Langmuir Probe Theory

Improved Abel Method for Low Sampling Points Situation and Experimental Verification of Electron Density Distribution Microwave Diagnosis

Real Time Measurement of Electron Temperature using Coupled Center Tapped Emissive and Langmuir Probe (CCTELP)

Probe method to measure the electromagnetic field in a plasma by Poynting vector conversion

Langmuir Probe Diagnosis of a Cold Atmospheric Plasma Jet