Abstract:In the photovoltaic (PV) system, the electrical characterization of series arc faults would be inevitably interfered by power electronic equipment. Existing methods are unable to effectively separate clear arc fault features from these influence factors, forming some unwanted detection barriers. In this paper, series arc fault experiments are conducted in PV systems with different kinds of power electronic equipment first. Having analyzed PV series arc faults through the existing linear transform, arc faults are hard to be identified in the undesired switching frequency band and harmonics because of noise interferences. Through establishment of effectiveness evaluation index, more performance limitations are discovered in low- and high-frequency bands for the bandpass filter effect of the linear transform. Then the arc fault identification in high and switching frequency bands become much easier after the investigation of the bilinear transform with higher time–frequency resolution. However, the performance is not obviously improved in the low-frequency band because of the cross term. Next, arc fault features in low and switching frequency bands would be more obvious through application of the adaptive transform. Besides, performances just have a slight decrease in the high-frequency band. These better time–frequency distributions are of great benefit to improve the detection accuracy and expand the application scope. Finally, the arc fault model is proposed to acquire the simulated data in the PV system with the power electronic equipment. It is found that the power electronic equipment would seriously interfere arc fault behaviors in the low and switching frequency bands.

Permanent fault identification method based on parameter identification for photovoltaic access to distribution network

Research on a Line Protection Method for DC Distribution System Based on Parameter Identification

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Identification of Permanent Fault at Transmission Lines with Shunt Reactors Based on Waveform Correlation

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

A Novel Fault Diagnosis Scheme for PV Plants Based on Real-Time System State Identification

Identification of Permanent Faults for Three-Phase Adaptive Reclosure Based on Waveform Characteristics of Differential Mode Currents in Shunt Reactors

Permanent fault identification for distribution network based on characteristic frequency signal injection using power electronic technology

A Fast MPPT-based Anomaly Detection and Accurate Fault Diagnosis Technique for PV Arrays

Novel Fault Locating Method Based on Synchronized Voltage Phasor

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

A Novel Methodology for Partial Shading Diagnosis Using the Electrical Parameters of Photovoltaic Strings

Fault Diagnosis and Classification in Photovoltaic Systems Using SCADA Data

Photovoltaic fault detection using a parameter based model

A compound fault diagnosis model for photovoltaic array based on 1D VoVNet-SVDD by considering unknown faults

An Identification Method for Asymmetric Faults With Line Breaks Based on Low-Voltage Side Data in Distribution Networks

A Method Based on NGO-HKELM for the Autonomous Diagnosis of Semiconductor Power Switch Open-Circuit Faults in Three-Phase Grid-Connected Photovoltaic Inverters

Time–Frequency Distribution Characteristic and Model Simulation of Photovoltaic Series Arc Fault With Power Electronic Equipment

Transient Fault Current Calculation Method for the PV Grid-Connected System Considering Dynamic Response of PLL

A novel noniterative single-ended fault location method with distributed parameter model for AC transmission lines

Identification of Distribution Network Topology and Line Parameter Based on Smart Meter Measurements