Abstract:With the development of distributed generation and the corresponding importance of the P.V. (photovoltaic) system, it is desired to operate a P.V. system efficiently and reliably. To ensure such an operation, a monitoring system is required to diagnose the health of the system. This paper aims to analyze a P.V. system under various operating conditions to identify parameters-derived from the I-V (current-voltage) characteristics of the P.V. system-that could serve as electrical signatures to various faulty operations and facilitate in devising a monitoring algorithm for the system. A model-based approach has been adopted to represent a P.V. system, using a one-diode model of a practical P.V. cell, developed in MATLAB/Simulink. The modelled system comprises two arrays, while each array has two panels in series. It was simulated for various operating conditions: healthy condition represented by STC (Standard Testing Condition), O.C. (open-circuited), soiling, P.S. (partial-shading), H.S. (panels hotspots) and P.D. (panels degradation) conditions. For the analysis of I-V curves under these conditions, six derived parameters were selected: Vte (equivalent thermal voltage), MCPF (maximum current point factor), Ri (currents ratio), S (slope), and Dv and Di (voltages and currents differences, respectively). Using these parameters, data of the actual system under various conditions were compared with its model-generated data for healthy operating conditions. Thresholds were set for each parameter's value to mark normal operation range. It was observed that almost each considered fault creates a unique combination of sensitive parameters whose values exceeds the pre-defined thresholds, creating an electrical signature that will appear only when the corresponding conditions on the system are achieved. Based on these signatures, an algorithm has been proposed in this study which aims to identify and classify the considered faults. In comparison to other such studies, this work has been focused on those sensitive parameters for faults identification which shows greater sensitivity and contribute more to creation of unique sets of sensitive parameters for considered faults.

Photovoltaic fault detection using a parameter based model

Identifying PV Module Mismatch Faults by a Thermography-Based Temperature Distribution Analysis

Model-Based Development of a Diagnostic Algorithm for Central Inverter Thermal Management System Fault Detection and Isolation

A hybrid data-driven modeling method on sensor condition monitoring and fault diagnosis for power plants

A Novel Fault Diagnosis Scheme for PV Plants Based on Real-Time System State Identification

A Fast MPPT-based Anomaly Detection and Accurate Fault Diagnosis Technique for PV Arrays

Parameter Estimation and Preliminary Fault Diagnosis for Photovoltaic Modules Using a Three-Diode Model

A Robust Parametrization Method of Photovoltaic Modules for Enhancing One-Diode Model Accuracy under Varying Operating Conditions

Research on real-time identification method of model parameters for the photovoltaic array

A Multi-State Dynamic Thermal Model for Accurate Photovoltaic Cell Temperature Estimation

A model-based approach for detecting and identifying faults on the D.C. side of a P.V. system using electrical signatures from I-V characteristics

A compound fault diagnosis model for photovoltaic array based on 1D VoVNet-SVDD by considering unknown faults

An Intelligent Fault Detection Model for Fault Detection in Photovoltaic Systems

Intelligent fault diagnosis of photovoltaic array based on variable predictive models and I–V curves

A fault diagnosis method for photovoltaic module current mismatch based on numerical analysis and statistics

A Novel Methodology for Partial Shading Diagnosis Using the Electrical Parameters of Photovoltaic Strings

Photovoltaic Plant Metering Monitoring Model And Its Calibration And Parameter Assessment

A Photovoltaic Fault Diagnosis Method Integrating Photovoltaic Power Prediction and EWMA Control Chart

Novel Modeling Framework for PV Faults Under Partial Shading

Fast simulation modeling and multiple-PS fault diagnosis of the PV array based on I–V curve conversion

Fault Diagnosis and Detection Based on Efficiency Loss Test of Photovoltaic Power Station