Abstract:This paper reports the fatigue analysis for a failure of a shaft in a wind turbine in which reinforced-welding elbow to support the shaft load. The shaft was broken near the reinforcing elbow. When designing mechanical and structural components, the diameter and the characteristics of materials have been considered not to exceed the permissible limit. However, after 40 days of the cycle operation, the shaft was broken at the accepted loading conditions within reasonable limits at a wind speed of 6-10 m/s. The crack initiate fatigue in the shaft is influenced by many variables that may due to uniaxial, bending, torsion, the shape of loading curve, part size, part finish, operating temperature, and atmosphere. For these reasons, it is important to investigate the fatigue behavior on the failure of the shaft. The main goal is to investigate and analyze the fatigue behavior on a broken shaft of the wind turbine gearbox to determine the features that cause the failure. A microscopic investigation of the fatigue-fracture surface was done. The microscopic analysis was carried out in terms of the chemical composition using ARL Spark Spectrometer, energy dispersive spectroscopy (EDS), the morphology of the fatigue by using scanning electron microscopy (SEM) and hardness test. Moreover, a theoretical analysis was made to illustrate the results and comparison between these results and the corresponding stress distribution data from a finite element method (FEM) simulation to know how the fatigue fracture began and propagated along the shaft. The result of the analysis shows that the fatigue occurred due to the unbalanced of the bending and torsion stress in the junction of the reinforced-welding elbow with hardness testing at the extreme cracking area is 435 HV. It is emphasized that the microstructure of fatigue surface structure shows sensitization to facilitate intergranular cracking and fatigue corrosion.

ANALYSIS OF TORSION FAILURE OF MOTOR SHAFT

Fracture Analysis on Pins of Hoist Chains of a Bucket Elevator

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

Fracture Analysis of U Shape Bolts for Automobile

Fracture failure analysis and structure improvement on thread joint of turbine shaft

Fracture Mechanics Analysis of Fatigue Failures in Crankshafts With Drilled Holes and Surface Compression

Fracture Failure Analysis of Bearing Outer Race in Motors of Blower

Analysis and Research on Fracture Cause of Fixed Shaft of Torsion Arm of Wind Turbine Gearbox

Failure Analysis of Torsion Shaft of Air Starter to External Gear Box of an Aero-engine: A Case of Complete Shear

Experimental Study and Finite Element Analysis on the Fatigue Strength of Torsion Shaft

Static property analyses based on finite element method and torsion tests on carbon fibre composite motor drive shaft

Failure Analysis of Drive Axle Shaft failed under Torsional Stress

Failure Analysis on the Rear Axle Shaft of Automobile

Analysis of Fatigue Cracking for Turbine Blade

Fatigue Failure Analysis of Shaft in As-developed Wind Turbine with Reinforced-welding Elbow

Failure modes, mechanisms and causes of shafts in mechanical equipment

The Effects Of Longitudinal And Circumferential Cracks On The Torsional Dynamic Response Of Shafts

Failure analysis and improvement of a 42CrMo crankshaft for a heavy-duty truck

Failure Analysis of Fatigue Fracture on the Outer Ring of a Cylindrical Roller Bearing in an Air Blower Motor

Failure analysis of a high strength Cr-containing tube used in an oil well

Investigation of Traction Sheave Failure: Experimental and Finite Element Analysis