Abstract:Rail grinders belonging to special vehicles have fewer accidents than general railroad vehicles and parts, and the causes are diverse. Therefore, there is a lack of basic data for inspection methods and preventative measures necessary for accident prevention, and the collection and analysis of accident cases are also necessary. In this paper, a failure analysis of the recently derailed rail grinding car's rotating shaft was conducted. Various analyses, including fractography, chemical analysis, metallography and hardness measurement, were performed on the failed shaft. In the fracture surface of the shaft, ratchet marks and fatigue striations indicative of fatigue failure were observed. Consequently, it was confirmed that the failure of the shaft was attributed to fatigue, with the primary cause being identified as the cracks found on the fillet area surface. Chemical analysis of the observed inclusions in the sample revealed manganese (Mn) at 6.16 wt% and sulfur (S) at 1.35 wt%. These are attributed to non-metallic MnS inclusions, which are presumed to have adversely affected the fatigue strength of the material. Additionally, hardness deficiency due to heat treatment defects on the shaft surface was identified. The surface hardness measured approximately HV400, suggesting that it is desirable to achieve a surface hardness of HV600 or HRC55 or higher during high-frequency heat treatment. Lastly, the finish state of the fillet area surface was not smooth. Given that the fillet area is a region where stress concentration occurs, the presence of such machining traces raises the possibility of progressing into fatigue cracks. Finite element analysis revealed that the von-Mises stress was less than the yield strength of the material, and a safety factor based on the yield strength was calculated to be 3.5. The results confirmed that fatigue cracks in the fillet area were caused by the hardness deficiency due to the poor heat treatment, the rough surface finish, and the presence of non-metallic inclusions.

Failure Analysis of Drive Axle Shaft failed under Torsional Stress

Failure Analysis of Torsion Shaft of Air Starter to External Gear Box of an Aero-engine: A Case of Complete Shear

A Study on Intensification Coefficient Model for Half Shaft of Automotive Driving Axle Based on Lab Test

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

ANALYSIS STUDY ON BENDING FATIGUE TEST OF AUTOMOBILE WHEELS

Failure Analysis on the Rear Axle Shaft of Automobile

Failure Mechanism of Rear Drive Shaft in a Modified Pickup Truck

Static & Fracture Analysis and Design Optimization of Drive Shaft in Long Distance Belt Conveyor

Failure Analysis on Main Drive System of Tracked Vehicles

Static property analyses based on finite element method and torsion tests on carbon fibre composite motor drive shaft

Failure analysis of an elevator drive shaft

Failure Analysis of the Half-Shafts Belonging to a Three-Wheeled Electric Vehicle

Analysis of Bearing Failures in a Typical High-Power Marine Gearbox

ANALYSIS OF TORSION FAILURE OF MOTOR SHAFT

Failure Analysis of Crankshaft in a Heavy-duty Vehicle Engine

Finite-Element Analysis on Lightweight Material of Drive Axle Housing

Effects of Geometry Design Parameters on the Fatigue Failure of a Drive Axle Housing using Finite Element Analysis

Failure Analysis of a Gearbox of a Conveyor Belt

Fatigue failure prediction through Factor of Safety and Stress concentration in a malfunctioned AISI 4140 Automotive Crankshaft

Failure Analysis and Design Modification of Mandrel in Chassis Tube Bending Machine

Failure analysis of the rotating shaft in the rail grinding car