Abstract:Rail grinders belonging to special vehicles have fewer accidents than general railroad vehicles and parts, and the causes are diverse. Therefore, there is a lack of basic data for inspection methods and preventative measures necessary for accident prevention, and the collection and analysis of accident cases are also necessary. In this paper, a failure analysis of the recently derailed rail grinding car's rotating shaft was conducted. Various analyses, including fractography, chemical analysis, metallography and hardness measurement, were performed on the failed shaft. In the fracture surface of the shaft, ratchet marks and fatigue striations indicative of fatigue failure were observed. Consequently, it was confirmed that the failure of the shaft was attributed to fatigue, with the primary cause being identified as the cracks found on the fillet area surface. Chemical analysis of the observed inclusions in the sample revealed manganese (Mn) at 6.16 wt% and sulfur (S) at 1.35 wt%. These are attributed to non-metallic MnS inclusions, which are presumed to have adversely affected the fatigue strength of the material. Additionally, hardness deficiency due to heat treatment defects on the shaft surface was identified. The surface hardness measured approximately HV400, suggesting that it is desirable to achieve a surface hardness of HV600 or HRC55 or higher during high-frequency heat treatment. Lastly, the finish state of the fillet area surface was not smooth. Given that the fillet area is a region where stress concentration occurs, the presence of such machining traces raises the possibility of progressing into fatigue cracks. Finite element analysis revealed that the von-Mises stress was less than the yield strength of the material, and a safety factor based on the yield strength was calculated to be 3.5. The results confirmed that fatigue cracks in the fillet area were caused by the hardness deficiency due to the poor heat treatment, the rough surface finish, and the presence of non-metallic inclusions.

Failure Analysis on the Rear Axle Shaft of Automobile

A Study on Intensification Coefficient Model for Half Shaft of Automotive Driving Axle Based on Lab Test

Fracture Analysis of U Shape Bolts for Automobile

FAILURE ANALYSIS TO THE CRACKING IN THE AXLE SLEEVE OF GCr15 STEEL

Failure Analysis of Drive Axle Shaft failed under Torsional Stress

Fracture failure analysis of vertical arm of rear axle

Failure analysis on the plumbing arm of automobile steering gear

Fracture Analysis of the Transmission Shaft in Screw-Drilling Device

Failure Analysis of Crankshaft in a Heavy-duty Vehicle Engine

Failure Mechanism of Rear Drive Shaft in a Modified Pickup Truck

Cause Analysis on Microstructure Change for Rings of Failure Bearings

ANALYSIS OF TORSION FAILURE OF MOTOR SHAFT

Failure modes, mechanisms and causes of shafts in mechanical equipment

Failure Analysis of Cold Rotary Swaging Die

Failure analysis and improvement of a 42CrMo crankshaft for a heavy-duty truck

Research on the failure mechanism of the high-speed train bearing steel under static load failure

Failure analysis of the rotating shaft in the rail grinding car

Metallurgical analysis on a bending failed pump-shaft made of 17-7PH precipitation-hardening stainless steel

Failure Forms and Restoration Methods of the Automotive Front Axle Roll Forging Die

Failure analysis for outer ring cracking of GCr15 rolling bearing

Investigation on Unpredicted Failure Flaking of Automobile Rear-Wheel Bearings