Abstract:Rail grinders belonging to special vehicles have fewer accidents than general railroad vehicles and parts, and the causes are diverse. Therefore, there is a lack of basic data for inspection methods and preventative measures necessary for accident prevention, and the collection and analysis of accident cases are also necessary. In this paper, a failure analysis of the recently derailed rail grinding car's rotating shaft was conducted. Various analyses, including fractography, chemical analysis, metallography and hardness measurement, were performed on the failed shaft. In the fracture surface of the shaft, ratchet marks and fatigue striations indicative of fatigue failure were observed. Consequently, it was confirmed that the failure of the shaft was attributed to fatigue, with the primary cause being identified as the cracks found on the fillet area surface. Chemical analysis of the observed inclusions in the sample revealed manganese (Mn) at 6.16 wt% and sulfur (S) at 1.35 wt%. These are attributed to non-metallic MnS inclusions, which are presumed to have adversely affected the fatigue strength of the material. Additionally, hardness deficiency due to heat treatment defects on the shaft surface was identified. The surface hardness measured approximately HV400, suggesting that it is desirable to achieve a surface hardness of HV600 or HRC55 or higher during high-frequency heat treatment. Lastly, the finish state of the fillet area surface was not smooth. Given that the fillet area is a region where stress concentration occurs, the presence of such machining traces raises the possibility of progressing into fatigue cracks. Finite element analysis revealed that the von-Mises stress was less than the yield strength of the material, and a safety factor based on the yield strength was calculated to be 3.5. The results confirmed that fatigue cracks in the fillet area were caused by the hardness deficiency due to the poor heat treatment, the rough surface finish, and the presence of non-metallic inclusions.

Investigation of Traction Sheave Failure: Experimental and Finite Element Analysis

Fracture Analysis on Pins of Hoist Chains of a Bucket Elevator

Failure analysis of an elevator drive shaft

Component Structural Equivalent Research Based on Different Failure Strength Criterions and the Theory of Critical Distance

Failure Analysis of a Fractured Steel Track-type Chain Caused by High-cycle Fatigue of the Clamp Holder

Finite Element Analysis for Flat Head Sleeve of Slipper-Type Universal Spindles and Research on Their Fracture Causes

Failure Analysis of Torsion Shaft of Air Starter to External Gear Box of an Aero-engine: A Case of Complete Shear

Failure analysis of the rotating shaft in the rail grinding car

Fracture analysis on involute spline of large tunnel boring machine

Finite Element Modeling and Analysis of the Rope-Sheave Traction Behavior and Mechanism

Numerical Simulation on Failure Process of Rubber-Sleeved Headed Stud Shear Connector

Investigation of the causes of the fracture of the drive shaft of the electric locomotive

ANALYSIS OF TORSION FAILURE OF MOTOR SHAFT

Experimental Investigation of Friction and Slip at the Traction Interface of Rope and Sheave

Experimental Study and Finite Element Analysis on the Fatigue Strength of Torsion Shaft

Failure Analysis of a Failed Connecting Rod Cap and Connecting Bolts of a Reciprocating Compressor

Failure analysis of an involute spline coupling of an overhead bridge crane

Failure Analysis of Architectural Windlass' Braked Wheel

Failure Analysis of Escalator Step Induced by the Bolt Surface Defects

Failure Analysis of the Half-Shafts Belonging to a Three-Wheeled Electric Vehicle

Experimental characterization of traction-separation laws for interlaminar fracture in geometrically-scaled composites using progressive digital image correlation and through-thickness deformation analysis